[PATCH 11/17] thermal: rockchip_thermal: enable/check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

* Enable/check sensor explicitly in rockchip_thermal_probe() (also
  check sensor after doing chipset specific control operation).

* Remove superfluous second sensor enable/check attempt.

Cc: Heiko Stuebner <heiko@xxxxxxxxx>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
This driver may require some more fixing (probably IRQ should be
requested after ->control call).

 drivers/thermal/rockchip_thermal.c | 10 ++++------
 1 file changed, 4 insertions(+), 6 deletions(-)

diff --git a/drivers/thermal/rockchip_thermal.c b/drivers/thermal/rockchip_thermal.c
index 500cfc3..0b3509b 100644
--- a/drivers/thermal/rockchip_thermal.c
+++ b/drivers/thermal/rockchip_thermal.c
@@ -1161,9 +1161,6 @@ static int rockchip_configure_from_dt(struct device *dev,
 		return error;
 	}
 
-	thermal_zone_device_toggle(sensor->tzd, true);
-	thermal_zone_device_check(sensor->tzd);
-
 	return 0;
 }
 
@@ -1272,6 +1269,9 @@ static int rockchip_thermal_probe(struct platform_device *pdev)
 		}
 	}
 
+	for (i = 0; i < thermal->chip->chn_num; i++)
+		thermal_zone_device_toggle((&thermal->sensors[i])->tzd, true);
+
 	error = devm_request_threaded_irq(&pdev->dev, irq, NULL,
 					  &rockchip_thermal_alarm_irq_thread,
 					  IRQF_ONESHOT,
@@ -1284,10 +1284,8 @@ static int rockchip_thermal_probe(struct platform_device *pdev)
 
 	thermal->chip->control(thermal->regs, true);
 
-	for (i = 0; i < thermal->chip->chn_num; i++) {
-		thermal_zone_device_toggle((&thermal->sensors[i])->tzd, true);
+	for (i = 0; i < thermal->chip->chn_num; i++)
 		thermal_zone_device_check((&thermal->sensors[i])->tzd);
-	}
 
 	platform_set_drvdata(pdev, thermal);
 
-- 
1.9.1