[PATCH 13/17] thermal: tegra: enable/check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

Enable/check sensor after setting zone->tz and programming hwtrips.

Cc: Thierry Reding <thierry.reding@xxxxxxxxx>
Cc: Jonathan Hunter <jonathanh@xxxxxxxxxx>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
 drivers/thermal/tegra/soctherm.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/tegra/soctherm.c b/drivers/thermal/tegra/soctherm.c
index 9554613..81784b8 100644
--- a/drivers/thermal/tegra/soctherm.c
+++ b/drivers/thermal/tegra/soctherm.c
@@ -1400,9 +1400,6 @@ static int tegra_soctherm_probe(struct platform_device *pdev)
 			goto disable_clocks;
 		}
 
-		thermal_zone_device_toggle(z, true);
-		thermal_zone_device_check(z);
-
 		zone->tz = z;
 		tegra->thermctl_tzs[soc->ttgs[i]->id] = z;
 
@@ -1410,6 +1407,9 @@ static int tegra_soctherm_probe(struct platform_device *pdev)
 		err = tegra_soctherm_set_hwtrips(&pdev->dev, soc->ttgs[i], z);
 		if (err)
 			goto disable_clocks;
+
+		thermal_zone_device_toggle(z, true);
+		thermal_zone_device_check(z);
 	}
 
 	soctherm_debug_init(pdev);
-- 
1.9.1