Re: [PATCH] net: dsa: b53: Replace mdelay with msleep in b53_switch_reset_gpio

From: Florian Fainelli
Date: Wed Apr 11 2018 - 12:19:24 EST


On 04/11/2018 12:14 AM, Jia-Ju Bai wrote:
>
>
> On 2018/4/11 13:30, Phil Reid wrote:
>> On 11/04/2018 09:51, Jia-Ju Bai wrote:
>>> b53_switch_reset_gpio() is never called in atomic context.
>>>
>>> The call chain ending up at b53_switch_reset_gpio() is:
>>> [1] b53_switch_reset_gpio() <- b53_switch_reset() <-
>>> ÂÂÂ b53_reset_switch() <- b53_setup()
>>>
>>> b53_switch_reset_gpio() is set as ".setup" in struct dsa_switch_ops.
>>> This function is not called in atomic context.
>>>
>>> Despite never getting called from atomic context,
>>> b53_switch_reset_gpio()
>>> calls mdelay() to busily wait.
>>> This is not necessary and can be replaced with msleep() to
>>> avoid busy waiting.
>>>
>>> This is found by a static analysis tool named DCNS written by myself.
>>> And I also manually check it.
>>>
>>> Signed-off-by: Jia-Ju Bai <baijiaju1990@xxxxxxxxx>
>>> ---
>>> Â drivers/net/dsa/b53/b53_common.c | 4 ++--
>>> Â 1 file changed, 2 insertions(+), 2 deletions(-)
>>>
>>> diff --git a/drivers/net/dsa/b53/b53_common.c
>>> b/drivers/net/dsa/b53/b53_common.c
>>> index 274f367..e070ff6 100644
>>> --- a/drivers/net/dsa/b53/b53_common.c
>>> +++ b/drivers/net/dsa/b53/b53_common.c
>>> @@ -597,10 +597,10 @@ static void b53_switch_reset_gpio(struct
>>> b53_device *dev)
>>> ÂÂÂÂÂ /* Reset sequence: RESET low(50ms)->high(20ms)
>>> ÂÂÂÂÂÂ */
>>> ÂÂÂÂÂ gpio_set_value(gpio, 0);
>>> -ÂÂÂ mdelay(50);
>>> +ÂÂÂ msleep(50);
>>> ÂÂÂÂÂÂÂ gpio_set_value(gpio, 1);
>>> -ÂÂÂ mdelay(20);
>>> +ÂÂÂ msleep(20);
>>> ÂÂÂÂÂÂÂ dev->current_page = 0xff;
>>> Â }
>>>
>> Would that also imply gpio_set_value could be gpio_set_value_cansleep?
>>
>
> Yes, I think gpio_set_value_cansleep() is okay here?
> Do I need to send a V2 patch to replace gpio_set_value()?

Yes, I would lump these two changes in the same patch since this is
effectively about solving sleeping vs. non sleeping operations.

Thanks!
--
Florian