Hi Abhishek,
On Wed, 4 Apr 2018 18:12:24 +0530, Abhishek Sahu
<absahu@xxxxxxxxxxxxxx> wrote:
This patch does minor code reorganization for raw reads.
Currently the raw read is required for complete page but for
subsequent patches related with erased codeword bit flips
detection, only few CW should be read. So, this patch adds
helper function and introduces the read CW bitmask which
specifies which CW reads are required in complete page.
I am not sure this is the right approach for subpage reads. If the
controller supports it, you should just enable it in chip->options.
Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
---
drivers/mtd/nand/qcom_nandc.c | 186 +++++++++++++++++++++++++-----------------
1 file changed, 110 insertions(+), 76 deletions(-)
diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
index 40c790e..f5d1fa4 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c
@@ -1590,6 +1590,114 @@ static int check_flash_errors(struct qcom_nand_host *host, int cw_cnt)
}
/*
+ * Helper to perform the page raw read operation. The read_cw_mask will be
+ * used to specify the codewords for which the data should be read. The
+ * single page contains multiple CW. Sometime, only few CW data is required
+ * in complete page. Also, start address will be determined with
+ * this CW mask to skip unnecessary data copy from NAND flash device. Then,
+ * actual data copy from NAND controller to data buffer will be done only
+ * for the CWs which have the mask set.
+ */
+static int
+nandc_read_page_raw(struct mtd_info *mtd, struct nand_chip *chip,
+ u8 *data_buf, u8 *oob_buf,
+ int page, unsigned long read_cw_mask)
+{
+ struct qcom_nand_host *host = to_qcom_nand_host(chip);
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+ struct nand_ecc_ctrl *ecc = &chip->ecc;
+ int i, ret;
+ int read_loc, start_step, last_step;
+
+ nand_read_page_op(chip, page, 0, NULL, 0);
+
+ host->use_ecc = false;
+ start_step = ffs(read_cw_mask) - 1;
+ last_step = fls(read_cw_mask);
+
+ clear_bam_transaction(nandc);
+ set_address(host, host->cw_size * start_step, page);
+ update_rw_regs(host, last_step - start_step, true);
+ config_nand_page_read(nandc);
+
+ for (i = start_step; i < last_step; i++) {
+ int data_size1, data_size2, oob_size1, oob_size2;
+ int reg_off = FLASH_BUF_ACC;
+
+ data_size1 = mtd->writesize - host->cw_size * (ecc->steps - 1);
+ oob_size1 = host->bbm_size;
+
+ if (i == (ecc->steps - 1)) {
+ data_size2 = ecc->size - data_size1 -
+ ((ecc->steps - 1) << 2);
+ oob_size2 = (ecc->steps << 2) + host->ecc_bytes_hw +
+ host->spare_bytes;
+ } else {
+ data_size2 = host->cw_data - data_size1;
+ oob_size2 = host->ecc_bytes_hw + host->spare_bytes;
+ }
+
+ /*
+ * Don't perform actual data copy from NAND controller to data
+ * buffer through DMA for this codeword
+ */
+ if (!(read_cw_mask & BIT(i))) {
+ if (nandc->props->is_bam)
+ nandc_set_read_loc(nandc, 0, 0, 0, 1);
+
+ config_nand_cw_read(nandc, false);
+
+ data_buf += data_size1 + data_size2;
+ oob_buf += oob_size1 + oob_size2;
+
+ continue;
+ }
+
+ if (nandc->props->is_bam) {
+ read_loc = 0;
+ nandc_set_read_loc(nandc, 0, read_loc, data_size1, 0);
+ read_loc += data_size1;
+
+ nandc_set_read_loc(nandc, 1, read_loc, oob_size1, 0);
+ read_loc += oob_size1;
+
+ nandc_set_read_loc(nandc, 2, read_loc, data_size2, 0);
+ read_loc += data_size2;
+
+ nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
+ }
+
+ config_nand_cw_read(nandc, false);
+
+ read_data_dma(nandc, reg_off, data_buf, data_size1, 0);
+ reg_off += data_size1;
+ data_buf += data_size1;
+
+ read_data_dma(nandc, reg_off, oob_buf, oob_size1, 0);
+ reg_off += oob_size1;
+ oob_buf += oob_size1;
+
+ read_data_dma(nandc, reg_off, data_buf, data_size2, 0);
+ reg_off += data_size2;
+ data_buf += data_size2;
+
+ read_data_dma(nandc, reg_off, oob_buf, oob_size2, 0);
+ oob_buf += oob_size2;
+ }
+
+ ret = submit_descs(nandc);
+ if (ret)
+ dev_err(nandc->dev, "failure to read raw page\n");
+
+ free_descs(nandc);
+
+ if (!ret)
+ ret = check_flash_errors(host, last_step - start_step);
+
+ return 0;
+}
+
+/*
* reads back status registers set by the controller to notify page read
* errors. this is equivalent to what 'ecc->correct()' would do.
*/
@@ -1839,82 +1947,8 @@ static int qcom_nandc_read_page_raw(struct mtd_info *mtd,
struct nand_chip *chip, uint8_t *buf,
int oob_required, int page)
{
- struct qcom_nand_host *host = to_qcom_nand_host(chip);
- struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
- u8 *data_buf, *oob_buf;
- struct nand_ecc_ctrl *ecc = &chip->ecc;
- int i, ret;
- int read_loc;
-
- nand_read_page_op(chip, page, 0, NULL, 0);
- data_buf = buf;
- oob_buf = chip->oob_poi;
-
- host->use_ecc = false;
-
- clear_bam_transaction(nandc);
- update_rw_regs(host, ecc->steps, true);
- config_nand_page_read(nandc);
-
- for (i = 0; i < ecc->steps; i++) {
- int data_size1, data_size2, oob_size1, oob_size2;
- int reg_off = FLASH_BUF_ACC;
-
- data_size1 = mtd->writesize - host->cw_size * (ecc->steps - 1);
- oob_size1 = host->bbm_size;
-
- if (i == (ecc->steps - 1)) {
- data_size2 = ecc->size - data_size1 -
- ((ecc->steps - 1) << 2);
- oob_size2 = (ecc->steps << 2) + host->ecc_bytes_hw +
- host->spare_bytes;
- } else {
- data_size2 = host->cw_data - data_size1;
- oob_size2 = host->ecc_bytes_hw + host->spare_bytes;
- }
-
- if (nandc->props->is_bam) {
- read_loc = 0;
- nandc_set_read_loc(nandc, 0, read_loc, data_size1, 0);
- read_loc += data_size1;
-
- nandc_set_read_loc(nandc, 1, read_loc, oob_size1, 0);
- read_loc += oob_size1;
-
- nandc_set_read_loc(nandc, 2, read_loc, data_size2, 0);
- read_loc += data_size2;
-
- nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
- }
-
- config_nand_cw_read(nandc, false);
-
- read_data_dma(nandc, reg_off, data_buf, data_size1, 0);
- reg_off += data_size1;
- data_buf += data_size1;
-
- read_data_dma(nandc, reg_off, oob_buf, oob_size1, 0);
- reg_off += oob_size1;
- oob_buf += oob_size1;
-
- read_data_dma(nandc, reg_off, data_buf, data_size2, 0);
- reg_off += data_size2;
- data_buf += data_size2;
-
- read_data_dma(nandc, reg_off, oob_buf, oob_size2, 0);
- oob_buf += oob_size2;
- }
-
- ret = submit_descs(nandc);
- if (ret)
- dev_err(nandc->dev, "failure to read raw page\n");
-
- free_descs(nandc);
-
- if (!ret)
- ret = check_flash_errors(host, ecc->steps);
-
- return 0;
+ return nandc_read_page_raw(mtd, chip, buf, chip->oob_poi, page,
+ BIT(chip->ecc.steps) - 1);
I don't understand this. chip->ecc.steps is constant, right? So you
always ask for the same subpage?
}
/* implements ecc->read_oob() */