Re: sparc/ppc/arm compat siginfo ABI regressions: sending SIGFPE via kill() returns wrong values in si_pid and si_uid

[Linus Torvalds]

On Fri, Apr 13, 2018 at 11:45 AM, Dave Martin <Dave.Martin@xxxxxxx> wrote:
>
> Most uses I've seen do nothing more than use the FPE_xyz value to
> format diagnostic messages while dying.  I struggled to find code that
> made a meaningful functional decision based on the value, though that's
> not proof...

Yeah. I've seen code that cares about SIGFPE deeply, but it's almost
invariably about some emulated environment (eg Java VM, or CPU
emulation).

And the siginfo data is basically never good enough for those
environments anyway on its own, so they will go and look at the actual
instruction that caused the fault and the register state instead,
because they need *all* the information.

The cases that use si_code are the ones that just trapped signals in
order to give a more helpful abort message.

So I could certainly imagine that si_code is actually used by somebody
who then decides to actuall act differently on it, but aside from
perhaps printing out a different message, it sounds far-fetched.

                Linus