Re: [PATCH] arm: dts: am437x-sk-evm: add wilink8 support

[Sekhar Nori]

On Tuesday 01 May 2018 12:54 PM, Eyal Reizer wrote:
> enable mmc3 used for wlan and uart1 used for bluetooth
> configure the gpios used for wlan and bluetooth controls
> add fixed voltage regulator used for wlan power control
> 
> Signed-off-by: Eyal Reizer <eyalr@xxxxxx>

ARM should be capitalized in subject line.

> +
> +&mmc3 {
> +	status = "okay";
> +	/*
> +	 * these are on the crossbar and are outlined in the
> +	 * xbar-event-map element
> +	 */
> +	dmas = <&edma_xbar 30 0 1>,
> +		<&edma_xbar 31 0 2>;
> +	dma-names = "tx", "rx";
> +	vmmc-supply = <&vmmcwl_fixed>;
> +	bus-width = <4>;
> +	pinctrl-names = "default", "sleep";
> +	pinctrl-0 = <&mmc3_pins_default>;
> +	pinctrl-1 = <&mmc3_pins_sleep>;
> +	cap-power-off-card;
> +	keep-power-in-suspend;
> +	ti,non-removable;
> +
> +	#address-cells = <1>;
> +	#size-cells = <0>;
> +	wlcore: wlcore@0 {

wlcore@2

> +		compatible = "ti,wl1835";
> +		pinctrl-names = "default", "sleep";
> +		pinctrl-0 = <&wlan_pins_default>;
> +		pinctrl-1 = <&wlan_pins_sleep>;
> +		reg = <2>;
> +		interrupt-parent = <&gpio4>;
> +		interrupts = <13 IRQ_TYPE_LEVEL_HIGH>;
> +	};
> +};

Thanks,
Sekhar