Re: [PATCHv4 2/2] iommu/vt-d: Limit number of faults to clear in irq handler

[Dmitry Safonov]

On Thu, 2018-05-03 at 09:32 +0800, Lu Baolu wrote:
> Hi,
> 
> On 05/03/2018 08:52 AM, Dmitry Safonov wrote:
> > AFAICS, we're doing fault-clearing in a loop inside irq handler.
> > That means that while we're clearing if a fault raises, it'll make
> > an irq level triggered (or on edge) on lapic. So, whenever we
> > return
> > from the irq handler, irq will raise again.
> > 
> 
> Uhm, double checked with the spec. Interrupts should be generated
> since we always clear the fault overflow bit.
> 
> Anyway, we can't clear faults in a limited loop, as the spec says in
> 7.3.1:

Mind to elaborate?
ITOW, I do not see a contradiction. We're still clearing faults in FIFO
fashion. There is no limitation to do some spare work in between
clearings (return from interrupt, then fault again and continue).

> Software is expected to process the non-recoverable faults reported
> through the Fault Recording
> Registers in a circular FIFO fashion starting from the Fault
> Recording Register referenced by the Fault
> Recording Index (FRI) field, until it finds a Fault Recording
> Register with no faults (F field Clear).
> 
> Best regards,
> Lu Baolu

-- 
Thanks,
             Dmitry