Re: [RFC PATCH 3/5] net: macb: Add pm runtime support

[Harini Katakam]

Hi Claudiu,

On Thu, May 3, 2018 at 3:39 PM, Claudiu Beznea
<Claudiu.Beznea@xxxxxxxxxxxxx> wrote:
>
>
> On 22.03.2018 15:51, harinikatakamlinux@xxxxxxxxx wrote:
>> From: Harini Katakam <harinik@xxxxxxxxxx>
<snip>
> I would use a "goto" instruction, e.g.:
>                 value = -ETIMEDOUT;
>                 goto out;
>

Will do

>
> Below, in macb_open() you have a return err; case:
>         err = macb_alloc_consistent(bp);
>         if (err) {
>                 netdev_err(dev, "Unable to allocate DMA memory (error %d)\n",
>                            err);
>                 return err;
>         }
>
> You have to undo pm_runtime_get_sync() with pm_runtime_put_sync() or something
> similar to decrement dev->power.usage_count.

Will do

<snip>
>> @@ -4104,11 +4145,16 @@ static int macb_remove(struct platform_device *pdev)
>>               mdiobus_free(bp->mii_bus);
>>
>>               unregister_netdev(dev);
>> -             clk_disable_unprepare(bp->tx_clk);
>> -             clk_disable_unprepare(bp->hclk);
>> -             clk_disable_unprepare(bp->pclk);
>> -             clk_disable_unprepare(bp->rx_clk);
>> -             clk_disable_unprepare(bp->tsu_clk);
>> +             pm_runtime_disable(&pdev->dev);
>> +             pm_runtime_dont_use_autosuspend(&pdev->dev);
>> +             if (!pm_runtime_suspended(&pdev->dev)) {
>> +                     clk_disable_unprepare(bp->tx_clk);
>> +                     clk_disable_unprepare(bp->hclk);
>> +                     clk_disable_unprepare(bp->pclk);
>> +                     clk_disable_unprepare(bp->rx_clk);
>> +                     clk_disable_unprepare(bp->tsu_clk);
>> +                     pm_runtime_set_suspended(&pdev->dev);
>
> This is driver remove function. Shouldn't clocks be removed?

clk_disable_unprepare IS being done here.
The check for !pm_runtime_suspended is just to make sure the
clocks are not already removed (in runtime_suspend).

Regards,
Harini