[PATCH v2 03/14] dt-bindings: qcom_nandc: make nand-ecc-strength optional

[Abhishek Sahu]

Now, nand-ecc-strength is optional. If specified in DT, then
controller will use this ECC strength otherwise ECC strength will
be calculated according to chip requirement and available OOB size.

Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
---
* Changes from v1:

  NEW PATCH

 Documentation/devicetree/bindings/mtd/qcom_nandc.txt | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
index 73d336be..f246aa0 100644
--- a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
+++ b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
@@ -45,11 +45,13 @@ Required properties:
 			number (e.g., 0, 1, 2, etc.)
 - #address-cells:	see partition.txt
 - #size-cells:		see partition.txt
-- nand-ecc-strength:	see nand.txt
 - nand-ecc-step-size:	must be 512. see nand.txt for more details.
 
 Optional properties:
 - nand-bus-width:	see nand.txt
+- nand-ecc-strength:	see nand.txt. If not specified, then ECC strength will
+			be used according to chip requirement and available
+			OOB size.
 
 Each nandcs device node may optionally contain a 'partitions' sub-node, which
 further contains sub-nodes describing the flash partition mapping. See
-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc.
is a member of Code Aurora Forum, hosted by The Linux Foundation