Re: [PATCH 4/7] dt-bindings: gnss: add u-blox binding

[Johan Hovold]

On Fri, May 04, 2018 at 02:04:15PM +0200, H. Nikolaus Schaller wrote:

> It should be possible to cover this by a timer that is started
> in this case. If there is serdev data received after assuming the module
> is turned off, the driver has detected the wrong case - and can safely
> close the serdev until we want to have it powered on again.
> 
> If there is no response after turing off, the module power state is already
> in sync and we can close the serdev as well - after the timeout (let's say
> 30 seconds). Then, the serdev UART can idle. We should open the serdev
> and start this timer also in the probe function to catch an initially wrong
> state.

Right, the only thing that worried me about that was that we cannot
really delay system suspend for 30 seconds even if a somewhat shorter
delay should be probably be sufficient (still a number of seconds).

Configuring the serial controller as a wakeup source which aborts
suspend or resumes if the driver gets it wrong might be preferred to
draining the battery in suspend however.

Johan