Re: [PATCH v3 3/4] rtc: ds1307: add offset sysfs for mt41txx chips.

[Alexandre Belloni]

On 09/05/2018 21:33:54+0200, Giulio Benetti wrote:
> m41txx chips can hold a calibration value to get correct clock bias.
> If positive offset is passed, it means adding 512 cycles(@32.768Hz)
> every tick(1s).
> If negative offset is passed, it means subtracting 256 cycles(@32.768Hz)
> every tick(1s).
> 
> Add offset handling (ranging between (-31) and 31) via sysfs.
> 
> Signed-off-by: Giulio Benetti <giulio.benetti@xxxxxxxxxxxxxxxx>
> ---
>  drivers/rtc/rtc-ds1307.c | 70 ++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 70 insertions(+)
> 
> diff --git a/drivers/rtc/rtc-ds1307.c b/drivers/rtc/rtc-ds1307.c
> index 0ab0c166da83..33895668b363 100644
> --- a/drivers/rtc/rtc-ds1307.c
> +++ b/drivers/rtc/rtc-ds1307.c
> @@ -114,6 +114,16 @@ enum ds_type {
>  #	define RX8025_BIT_VDET		0x40
>  #	define RX8025_BIT_XST		0x20
>  
> +#define M41TXX_REG_CONTROL	0x07
> +#	define M41TXX_BIT_OUT		0x80
> +#	define M41TXX_BIT_FT		0x40
> +#	define M41TXX_BIT_CALIB_SIGN	0x20
> +#	define M41TXX_M_CALIBRATION	0x1f
> +
> +/* Min and max values supported with 'offset' interface by M41TXX */
> +#define M41TXX_MIN_OFFSET	(-31)
> +#define M41TXX_MAX_OFFSET	(31)
> +
>  struct ds1307 {
>  	enum ds_type		type;
>  	unsigned long		flags;
> @@ -146,6 +156,9 @@ struct chip_desc {
>  
>  static int ds1307_get_time(struct device *dev, struct rtc_time *t);
>  static int ds1307_set_time(struct device *dev, struct rtc_time *t);
> +static int ds1337_read_alarm(struct device *dev, struct rtc_wkalrm *t);
> +static int ds1337_set_alarm(struct device *dev, struct rtc_wkalrm *t);
> +static int ds1307_alarm_irq_enable(struct device *dev, unsigned int enabled);
>  static u8 do_trickle_setup_ds1339(struct ds1307 *, u32 ohms, bool diode);
>  static irqreturn_t rx8130_irq(int irq, void *dev_id);
>  static int rx8130_read_alarm(struct device *dev, struct rtc_wkalrm *t);
> @@ -155,6 +168,8 @@ static irqreturn_t mcp794xx_irq(int irq, void *dev_id);
>  static int mcp794xx_read_alarm(struct device *dev, struct rtc_wkalrm *t);
>  static int mcp794xx_set_alarm(struct device *dev, struct rtc_wkalrm *t);
>  static int mcp794xx_alarm_irq_enable(struct device *dev, unsigned int enabled);
> +static int m41txx_rtc_read_offset(struct device *dev, long *offset);
> +static int m41txx_rtc_set_offset(struct device *dev, long offset);
>  
>  static const struct rtc_class_ops rx8130_rtc_ops = {
>  	.read_time      = ds1307_get_time,
> @@ -172,6 +187,16 @@ static const struct rtc_class_ops mcp794xx_rtc_ops = {
>  	.alarm_irq_enable = mcp794xx_alarm_irq_enable,
>  };
>  
> +static const struct rtc_class_ops m41txx_rtc_ops = {
> +	.read_time      = ds1307_get_time,
> +	.set_time       = ds1307_set_time,
> +	.read_alarm	= ds1337_read_alarm,
> +	.set_alarm	= ds1337_set_alarm,
> +	.alarm_irq_enable = ds1307_alarm_irq_enable,
> +	.read_offset	= m41txx_rtc_read_offset,
> +	.set_offset	= m41txx_rtc_set_offset,
> +};
> +
>  static const struct chip_desc chips[last_ds_type] = {
>  	[ds_1307] = {
>  		.nvram_offset	= 8,
> @@ -227,10 +252,17 @@ static const struct chip_desc chips[last_ds_type] = {
>  		.irq_handler = rx8130_irq,
>  		.rtc_ops = &rx8130_rtc_ops,
>  	},
> +	[m41t0] = {
> +		.rtc_ops	= &m41txx_rtc_ops,
> +	},
> +	[m41t00] = {
> +		.rtc_ops	= &m41txx_rtc_ops,
> +	},
>  	[m41t11] = {
>  		/* this is battery backed SRAM */
>  		.nvram_offset	= 8,
>  		.nvram_size	= 56,
> +		.rtc_ops	= &m41txx_rtc_ops,
>  	},
>  	[mcp794xx] = {
>  		.alarm		= 1,
> @@ -972,6 +1004,44 @@ static int mcp794xx_alarm_irq_enable(struct device *dev, unsigned int enabled)
>  				  enabled ? MCP794XX_BIT_ALM0_EN : 0);
>  }
>  
> +static int m41txx_rtc_read_offset(struct device *dev, long *offset)
> +{
> +	struct ds1307 *ds1307 = dev_get_drvdata(dev);
> +	unsigned int ctrl_reg;
> +	u8 val;
> +
> +	regmap_read(ds1307->regmap, M41TXX_REG_CONTROL, &ctrl_reg);
> +
> +	val = ctrl_reg & M41TXX_M_CALIBRATION;
> +
> +	/* check if positive */
> +	if (ctrl_reg & M41TXX_BIT_CALIB_SIGN)
> +		*offset = val;
> +	else
> +		*offset = -val;
> +

This is definitively not right, you have to convert to/from ppb when
reading/setting the offset. The datasheet gives you the correct steps in
ppm.

> +	return 0;
> +}
> +
> +static int m41txx_rtc_set_offset(struct device *dev, long offset)
> +{
> +	struct ds1307 *ds1307 = dev_get_drvdata(dev);
> +	unsigned int ctrl_reg;
> +
> +	if ((offset < M41TXX_MIN_OFFSET) || (offset > M41TXX_MAX_OFFSET))
> +		return -ERANGE;
> +
> +	regmap_read(ds1307->regmap, M41TXX_REG_CONTROL, &ctrl_reg);
> +
> +	ctrl_reg &= ~M41TXX_M_CALIBRATION;
> +	ctrl_reg |= abs(offset) & M41TXX_M_CALIBRATION;
> +
> +	if (offset >= 0)
> +		ctrl_reg |= M41TXX_BIT_CALIB_SIGN;
> +
> +	return regmap_write(ds1307->regmap, M41TXX_REG_CONTROL,	ctrl_reg);

Please use regmap_update_bits

> +}
> +
>  /*----------------------------------------------------------------------*/
>  
>  static int ds1307_nvram_read(void *priv, unsigned int offset, void *val,
> -- 
> 2.17.0
> 

-- 
Alexandre Belloni, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com