Re: [PATCH v3] net: phy: DP83TC811: Introduce support for the DP83TC811 phy

[Andrew Lunn]

On Fri, May 11, 2018 at 01:51:28PM -0500, Dan Murphy wrote:
> Andrew
> 
> On 05/11/2018 01:30 PM, Andrew Lunn wrote:
> > On Fri, May 11, 2018 at 01:08:19PM -0500, Dan Murphy wrote:
> >> Add support for the DP83811 phy.
> >>
> >> The DP83811 supports both rgmii and sgmii interfaces.
> >> There are 2 part numbers for this the DP83TC811R does not
> >> reliably support the SGMII interface but the DP83TC811S will.
> >>
> >> There is not a way to differentiate these parts from the
> >> hardware or register set.  So this is controlled via the DT
> >> to indicate which phy mode is required.  Or the part can be
> >> strapped to a certain interface.
> >>
> >> Data sheet can be found here:
> >> http://www.ti.com/product/DP83TC811S-Q1/description
> >> http://www.ti.com/product/DP83TC811R-Q1/description
> >>
> >> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> > 
> > Hi Dan
> > 
> > It is normal to add any Reviewed-by, or Tested-by: tags you received,
> > so long as you don't make major changes.
> > 
> 
> Thanks for the reminder.
> 
> I usually add them if I get them explicitly stated in the review.

Humm, i thought i had given one. But i cannot find it in the mail
archive. Going senile :-(

Reviewed-by: Andrew Lunn <andrew@xxxxxxx>

    Andrew