Re: Allwinner A64: Issue on external rtc clock to wifi chip
From: Jagan Teki
Date: Mon May 14 2018 - 05:42:55 EST
On Mon, May 14, 2018 at 2:36 PM, Maxime Ripard
<maxime.ripard@xxxxxxxxxxx> wrote:
> On Mon, May 14, 2018 at 02:34:22PM +0530, Jagan Teki wrote:
>> On Mon, May 14, 2018 at 1:57 PM, Maxime Ripard
>> <maxime.ripard@xxxxxxxxxxx> wrote:
>> > On Mon, May 14, 2018 at 01:34:56PM +0530, Jagan Teki wrote:
>> >> On Mon, May 14, 2018 at 1:27 PM, Maxime Ripard
>> >> <maxime.ripard@xxxxxxxxxxx> wrote:
>> >> > Hi,
>> >> >
>> >> > On Mon, May 14, 2018 at 12:37:49PM +0530, Jagan Teki wrote:
>> >> >> Hi Maxime and All,
>> >> >>
>> >> >> We are trying to bring-up AP6330 Wifi chip for A64 board. We noticed
>> >> >> to have an external rtc clock has driven from wifi chip.
>> >> >>
>> >> >> So the devicetree is configured according to this as below.
>> >> >>
>> >> >> / {
>> >> >> wifi_pwrseq: wifi-pwrseq {
>> >> >> compatible = "mmc-pwrseq-simple";
>> >> >> clocks = <&rtc 1>;
>> >> >> clock-names = "ext_clock";
>> >> >> reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */
>> >> >> post-power-on-delay-ms = <400>;
>> >> >> };
>> >> >> };
>> >> >>
>> >> >> &rtc {
>> >> >> clock-output-names = "rtc-osc32k", "rtc-osc32k-out";
>> >> >> clocks = <&osc32k>;
>> >> >> #clock-cells = <1>;
>> >> >> };
>> >> >>
>> >> >> &mmc1 {
>> >> >> pinctrl-names = "default";
>> >> >> pinctrl-0 = <&mmc1_pins>;
>> >> >> vmmc-supply = <®_dcdc1>;
>> >> >> vqmmc-supply = <®_eldo1>;
>> >> >> mmc-pwrseq = <&wifi_pwrseq>;
>> >> >> bus-width = <4>;
>> >> >> non-removable;
>> >> >> status = "okay";
>> >> >>
>> >> >> brcmf: wifi@1 {
>> >> >> reg = <1>;
>> >> >> compatible = "brcm,bcm4329-fmac";
>> >> >> interrupt-parent = <&r_pio>;
>> >> >> interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* WL-WAKE-AP: PL3 */
>> >> >> interrupt-names = "host-wake";
>> >> >> };
>> >> >> };
>> >> >>
>> >> >> And observed rtc-osc32k-out clock is never enabled[1] and the value of
>> >> >> LOSC_OUT_GATING is 0x0 which eventually not enabling
>> >> >> LOSC_OUT_GATING_EN
>> >> >>
>> >> >> Pls. let us know if we miss anything here?
>> >> >>
>> >> >> [1] https://paste.ubuntu.com/p/X2By4q8kD2/
>> >> >
>> >> > Could you paste your config and the logs from a boot to?
>> >>
>> >> .config
>> >> https://paste.ubuntu.com/p/w9w2KB7RFc/
>> >>
>> >> dmesg
>> >> https://paste.ubuntu.com/p/mrZGk5bWRR/
>> >
>> > This is kind of weird. Have you tested with a 4.17 kernel? We have
>> > runtime_pm changes lined up in next, so that might be a regression
>> > there, even though we tested it with Quentin at some point.
>>
>> This is 4.17-rc4 do you want to try it on 4.16 ?
>
> No, this is next-20180503. Please try with 4.17-rc4
Couldn't find any different in behaviour [2]
[2] https://paste.ubuntu.com/p/m3PGBwrv6W/