Re: [PATCH v2] arm64: dts: qcom: Collapse usb support into one node

[Stephen Boyd]

Quoting Yossi Mansharoff (2018-04-17 06:56:30)
> We currently have three device nodes for the same USB hardware
> block, as evident by the reuse of the same reg address multiple
> times. Now that the chipidea driver fully supports OTG with the
> MSM wrapper we can collapse all these nodes into one USB device
> node, reflecting the true nature of the hardware.

None of this makes sense. Commit text is totally bogus now.

> 
> diff --git a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
> index 9ff8487..1505921 100644
> --- a/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
> +++ b/arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi
> @@ -371,18 +372,18 @@
>                         adp-disable;
>                         hnp-disable;
>                         srp-disable;
> -                       dr_mode = "host";
> -                       pinctrl-names = "default";
> -                       pinctrl-0 = <&usb_sw_sel_pm>;
> +                       mux-controls = <&usb_switch>;
> +                       mux-control-names = "usb_switch";
> +
>                         ulpi {
>                                 phy {
>                                         v1p8-supply = <&pm8916_l7>;
>                                         v3p3-supply = <&pm8916_l13>;
> -                                       extcon = <&usb_id>;
>                                 };
>                         };
>                 };
>  
> +

Why the newline?

>                 lpass@7708000 {
>                         status = "okay";
>                 };
> @@ -512,11 +513,17 @@
>  
>         usb_id: usb-id {
>                 compatible = "linux,extcon-usb-gpio";
> -               vbus-gpio = <&msmgpio 121 GPIO_ACTIVE_HIGH>;
> +               id-gpio = <&msmgpio 121 GPIO_ACTIVE_HIGH>;

Hmm?

>                 pinctrl-names = "default";
>                 pinctrl-0 = <&usb_id_default>;
>         };
>  
> +       usb_switch: usb-switch {
> +               compatible = "gpio-mux";

Needs a better compatible string for the actual mux part. The gpio-mux
can come after that because it's generic, but it's good to record the
actual mux part too.

> +               mux-gpios = <&pm8916_gpios 4 GPIO_ACTIVE_HIGH>;
> +               #mux-control-cells = <0>;
> +       };