Re: [PATCH v11 00/27] ARM: davinci: convert to common clock frameworkâ

[Sekhar Nori]

Hi David,

On Friday 18 May 2018 10:18 PM, David Lechner wrote:
> This series converts mach-davinci to use the common clock framework.
> 
> The series works like this, the first 3 patches fix some issues with the clock
> drivers that have already been accepted into the mainline kernel.
> 
> Then, starting with "ARM: davinci: pass clock as parameter to
> davinci_timer_init()", we get the mach code ready for the switch by adding the
> code needed for the new clock drivers and adding #ifndef CONFIG_COMMON_CLK
> around the legacy clocks so that we can switch easily between the old and the
> new.
> 
> "ARM: davinci: switch to common clock framework" actually flips the switch
> to start using the new clock drivers. Then the next 8 patches remove all
> of the old clock code.
> 
> The final four patches add device tree clock support to the one SoC that
> supports it.
> 
> This series has been tested on TI OMAP-L138 LCDK (both device tree and legacy
> board file).

If you do end up sending a v12, you can leave out the mach-davinci
portions unless there are any changes you need to make. I will pick them
up from this series once the driver dependencies are merged.

I do hope the drivers/clk/* changes can be merged from v4.18.

Thanks,
Sekhar