[PATCH] mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS

[Geert Uytterhoeven]

The comment about offset zero was not updated when changing behavior:
  - Automatic offset calculation is indicated by OFFSET_CONTINUOUS,
  - Zero really means offset zero.

Fixes: b175d03dd2072836 ("[PATCH] mtd cmdlinepart: allow zero offset value")
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
 drivers/mtd/cmdlinepart.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/cmdlinepart.c b/drivers/mtd/cmdlinepart.c
index fbd5affc0acfe3fe..3ea44cff9b759e3c 100644
--- a/drivers/mtd/cmdlinepart.c
+++ b/drivers/mtd/cmdlinepart.c
@@ -190,7 +190,10 @@ static struct mtd_partition * newpart(char *s,
 		extra_mem = (unsigned char *)(parts + *num_parts);
 	}
 
-	/* enter this partition (offset will be calculated later if it is zero at this point) */
+	/*
+	 * enter this partition (offset will be calculated later if it is
+	 * OFFSET_CONTINUOUS at this point)
+	 */
 	parts[this_part].size = size;
 	parts[this_part].offset = offset;
 	parts[this_part].mask_flags = mask_flags;
-- 
2.7.4