Re: B53 DSA switch problem on Banana Pi-R1 on Fedora 26

[Florian Fainelli]

Hi,

On 05/22/2018 12:11 PM, Gerhard Wiesinger wrote:
> Hello,
> 
> I'm trying to get B53 DSA switch working on the Banana Pi-R1 on Fedora
> 26 to run (I will upgrade to Fedora 27 and Fedora 28 when networking
> works again). Previously the switch was configured with swconfig without
> any problems.
> 
> Kernel: 4.16.7-100.fc26.armv7hl
> 
> b53_common: found switch: BCM53125, rev 4
> 
> I see all interfaces: lan1 to lan4 and wan.
> 
> i get the following error messages:
> 
> # master and self, same results
> 
> bridge vlan add dev lan1 vid 101 pvid untagged self
> RTNETLINK answers: Operation not supported
> bridge vlan add dev lan2 vid 101 pvid untagged self
> RTNETLINK answers: Operation not supported
> bridge vlan add dev lan3 vid 101 pvid untagged self
> RTNETLINK answers: Operation not supported
> bridge vlan add dev lan4 vid 101 pvid untagged self
> RTNETLINK answers: Operation not supported
> 
> # No quite sure here regarding CPU interface and VLAN, because this
> changed with some patches, also from dsa.txt
> 
> bridge vlan add dev eth0 vid 101 self
> RTNETLINK answers: Operation not supported

That won't work, eth0 is the master DSA device, if you need to create a
VLAN on top it would be with vconfig and/or ip link

> 
> Planned network structure will be as with 4.7.x kernels:
> 
> br0 <=> eth0.101 <=> eth0 (vlan 101 tagged) <=> lan 1-lan4 (vlan 101
> untagged pvid)
> 
> br1 <=> eth0.102 <=> eth0 (vlan 102 tagged) <=> wan (vlan 102 untagged
> pvid)
> 
> I think the rest of the config is clear after some research now, but I
> provide details if that one worked well.
> 
> If necessary I can provide full commands & logs and further details.
> 
> Thank you.
> 
> Any ideas?

Do you have CONFIG_BRIDGE_VLAN_FILTERING=y enabled in your kernel?

> 
> Ciao,
> 
> Gerhard
> 
> 


-- 
Florian