Re: [PATCH] mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS

[Boris Brezillon]

On Tue, 22 May 2018 17:07:53 +0200
Geert Uytterhoeven <geert+renesas@xxxxxxxxx> wrote:

> The comment about offset zero was not updated when changing behavior:
>   - Automatic offset calculation is indicated by OFFSET_CONTINUOUS,
>   - Zero really means offset zero.
> 
> Fixes: b175d03dd2072836 ("[PATCH] mtd cmdlinepart: allow zero offset value")
> Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>

Applied.

Thanks,

Boris

> ---
>  drivers/mtd/cmdlinepart.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mtd/cmdlinepart.c b/drivers/mtd/cmdlinepart.c
> index fbd5affc0acfe3fe..3ea44cff9b759e3c 100644
> --- a/drivers/mtd/cmdlinepart.c
> +++ b/drivers/mtd/cmdlinepart.c
> @@ -190,7 +190,10 @@ static struct mtd_partition * newpart(char *s,
>  		extra_mem = (unsigned char *)(parts + *num_parts);
>  	}
>  
> -	/* enter this partition (offset will be calculated later if it is zero at this point) */
> +	/*
> +	 * enter this partition (offset will be calculated later if it is
> +	 * OFFSET_CONTINUOUS at this point)
> +	 */
>  	parts[this_part].size = size;
>  	parts[this_part].offset = offset;
>  	parts[this_part].mask_flags = mask_flags;