[PATCH 3/5] net: emaclite: update kernel-doc comments

From: Radhey Shyam Pandey
Date: Mon Jun 18 2018 - 07:50:39 EST


This patch fixes below kernel-doc warnings:

Function parameter or member 'maxlen' not described in 'xemaclite_recv_data'
Function parameter or member 'address'not described in 'xemaclite_set_mac_address'
Excess function parameter 'addr' description in 'xemaclite_set_mac_address'
No description found for return value of 'xemaclite_interrupt'
No description found for return value of 'xemaclite_mdio_write'
Function parameter or member 'dev' not described in 'xemaclite_mdio_setup'
Excess function parameter 'ofdev' description in 'xemaclite_mdio_setup'
No description found for return value of 'xemaclite_open'
No description found for return value of 'xemaclite_close'
Excess function parameter 'match' description in 'xemaclite_of_probe'

Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey@xxxxxxxxxx>
---
drivers/net/ethernet/xilinx/xilinx_emaclite.c | 15 ++++++++++++---
1 file changed, 12 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
index 8d84f58..0b41cc5 100644
--- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c
+++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c
@@ -369,6 +369,7 @@ static int xemaclite_send_data(struct net_local *drvdata, u8 *data,
* xemaclite_recv_data - Receive a frame
* @drvdata: Pointer to the Emaclite device private data
* @data: Address where the data is to be received
+ * @maxlen: Maximum supported ethernet packet length
*
* This function is intended to be called from the interrupt context or
* with a wrapper which waits for the receive frame to be available.
@@ -488,7 +489,7 @@ static void xemaclite_update_address(struct net_local *drvdata,
/**
* xemaclite_set_mac_address - Set the MAC address for this device
* @dev: Pointer to the network device instance
- * @addr: Void pointer to the sockaddr structure
+ * @address: Void pointer to the sockaddr structure
*
* This function copies the HW address from the sockaddr strucutre to the
* net_device structure and updates the address in HW.
@@ -637,6 +638,8 @@ static void xemaclite_rx_handler(struct net_device *dev)
* @dev_id: Void pointer to the network device instance used as callback
* reference
*
+ * Return: IRQ_HANDLED
+ *
* This function handles the Tx and Rx interrupts of the EmacLite device.
*/
static irqreturn_t xemaclite_interrupt(int irq, void *dev_id)
@@ -770,6 +773,8 @@ static int xemaclite_mdio_read(struct mii_bus *bus, int phy_id, int reg)
*
* This function waits till the device is ready to accept a new MDIO
* request and then writes the val to the MDIO Write Data register.
+ *
+ * Return: 0 upon success or a negative error upon failure
*/
static int xemaclite_mdio_write(struct mii_bus *bus, int phy_id, int reg,
u16 val)
@@ -803,7 +808,7 @@ static int xemaclite_mdio_write(struct mii_bus *bus, int phy_id, int reg,
/**
* xemaclite_mdio_setup - Register mii_bus for the Emaclite device
* @lp: Pointer to the Emaclite device private data
- * @ofdev: Pointer to OF device structure
+ * @dev: Pointer to OF device structure
*
* This function enables MDIO bus in the Emaclite device and registers a
* mii_bus.
@@ -903,6 +908,9 @@ static void xemaclite_adjust_link(struct net_device *ndev)
* This function sets the MAC address, requests an IRQ and enables interrupts
* for the Emaclite device and starts the Tx queue.
* It also connects to the phy device, if MDIO is included in Emaclite device.
+ *
+ * Return: 0 on success. -ENODEV, if PHY cannot be connected.
+ * Non-zero error value on failure.
*/
static int xemaclite_open(struct net_device *dev)
{
@@ -973,6 +981,8 @@ static int xemaclite_open(struct net_device *dev)
* This function stops the Tx queue, disables interrupts and frees the IRQ for
* the Emaclite device.
* It also disconnects the phy device associated with the Emaclite device.
+ *
+ * Return: 0, always.
*/
static int xemaclite_close(struct net_device *dev)
{
@@ -1064,7 +1074,6 @@ static const struct net_device_ops xemaclite_netdev_ops;
/**
* xemaclite_of_probe - Probe method for the Emaclite device.
* @ofdev: Pointer to OF device structure
- * @match: Pointer to the structure used for matching a device
*
* This function probes for the Emaclite device in the device tree.
* It initializes the driver data structure and the hardware, sets the MAC
--
2.7.4