Re: [PATCH] vmw_pvrdma: Release netdev when vmxnet3 module is removed

[Adit Ranadive]

On 6/28/18, 1:37 PM, "Jason Gunthorpe" <jgg@xxxxxxxx> wrote:
> On Thu, Jun 28, 2018 at 03:45:26PM -0400, Neil Horman wrote:
> > On Thu, Jun 28, 2018 at 12:59:46PM -0600, Jason Gunthorpe wrote:
> > > On Thu, Jun 28, 2018 at 09:59:38AM -0400, Neil Horman wrote:
> > > > On repeated module load/unload cycles, its possible for the pvrmda
> > > > driver to encounter this crash:
<snip>
> > > > @@ -962,6 +982,7 @@ static int pvrdma_pci_probe(struct pci_dev *pdev,
> > > >  	}
> > > >  
> > > >  	dev->netdev = pci_get_drvdata(pdev_net);
> > > > +	dev_hold(dev->netdev);

That doesn't seem right. If the vmxnet3 driver isn't loaded at all or failed
to create a netdev, you would be requesting a hold on a NULL netdev. What if
you moved this to after the if(!dev->netdev) check?

> > > >  	pci_dev_put(pdev_net);
> > > >  	if (!dev->netdev) {
> > > >  		dev_err(&pdev->dev, "failed to get vmxnet3 device\n");
> > > 
> > > I see a lot of new dev_hold's here, where are the matching
> > > dev_puts()?
> > > 
> I'm not sure I'd call 2 alot, but sure, there is a new dev_hold in the
> pvrdma_pci_probe routine, to hold a reference to the netdev that is looked up
> there.  It is balanced by the NETDEV_UNREGISTER case in
> pvrdma_netdevice_event_handle.  The UNREGISTER clause is also balancing the
> NETDEV_REGISTER case of the hanlder that looks up the matching netdev should a
> new device be registered.  Note that we will only hold a single device at a
> time, because a given pvrdma device only recongnizes a single vmxnet3 device
> (the one on function 0 of its own bus/device tuple).
> 
> I don't see how the dev_hold in pvrdma_pci_probe is undone during
> error unwind (eg goto err_free_cq_ring)
> 
> And I don't see how it is put when pvrdma_pci_remove() is called.

That's right. These seem missing as well.