[PATCH v2] thermal: i.MX: Allow thermal probe to fail gracefully in case of bad calibration.

[Jean-Christophe Dubois]

Without this fix, the thermal probe on i.MX6 might trigger a division
by zero exception later in the probe if the calibration does fail.

Note: This linux behavior (Division by zero in kernel) has been triggered
on a Qemu i.MX6 emulation where parameters in nvmem were not set. With this
fix the division by zero is not triggeed anymore as the thermal probe does
fail early.

Signed-off-by: Jean-Christophe Dubois <jcd@xxxxxxxxxxxxxxx>
Reviewed-by: Fabio Estevam <fabio.estevam@xxxxxxx>
---
v2 changes:
 - improved subject line
 - added thermal maintainers in the destination list.

 drivers/thermal/imx_thermal.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
index 334d98be03b9..b1f82d64253e 100644
--- a/drivers/thermal/imx_thermal.c
+++ b/drivers/thermal/imx_thermal.c
@@ -604,7 +604,10 @@ static int imx_init_from_nvmem_cells(struct platform_device *pdev)
 	ret = nvmem_cell_read_u32(&pdev->dev, "calib", &val);
 	if (ret)
 		return ret;
-	imx_init_calib(pdev, val);
+
+	ret = imx_init_calib(pdev, val);
+	if (ret)
+		return ret;
 
 	ret = nvmem_cell_read_u32(&pdev->dev, "temp_grade", &val);
 	if (ret)
-- 
2.17.1