Re: [PATCH v4 0/5] mtd: rawnand: denali: add new clocks and improve setup_data_interface

[Miquel Raynal]

Hi Masahiro,

Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> wrote on Sat, 23 Jun
2018 01:06:33 +0900:

> The ->setup_data_interface() hook needs to know the clock frequency.
> In fact, this IP needs three clocks, but the current driver does not
> represent it.  Thus, it is hard to understand what is the correct
> clock frequency.
> (at least, clock property is not described in the DT-binding at all.)
> 
> This series adds more clocks based on the IP datasheet, and document
> it in the DT binding.
> In the new binding, three clocks are required: core clock, bus interface
> clock, ECC engine clock.
> 
> 1/5 is a backport candidate to fix SOCFPGA.
> 
> 
> Masahiro Yamada (5):
>   mtd: rawnand: denali_dt: set clk_x_rate to 200 MHz unconditionally
>   mtd: rawnand: denali_dt: use dev as a shorthand of &pdev->dev
>   dt-binding: mtd: denali_dt: document clock property
>   mtd: rawnand: denali_dt: add more clocks based on IP datasheet
>   mtd: rawnand: denali: optimize timing parameters for data interface

Applied patches 2-5/5 to nand/next on top of v4-18.rc3 (to have the fix
1/5).

Thanks,
MiquÃl