[PATCH] mmc: sdhci-esdhc-imx: disable clocks before changing frequency

From: Stefan Agner
Date: Thu Jul 05 2018 - 07:39:46 EST


In the uSDHC case (e.g. i.MX 6) clocks only get disabled if frequency
is set to 0. However, it could be that the stack asks for a frequency
change while clocks are on. In that case the function clears the
divider registers (by clearing ESDHC_CLOCK_MASK) while the clock is
enabled! This causes a short period of time where the clock is
undivided (on a i.MX 6DL a clock of 196MHz has been measured).

For older IP variants the driver disables clock by clearing some bits
in ESDHC_SYSTEM_CONTROL.

Make sure to disable card clock before chainging frequency for uSDHC
IP variants too. Also fix indent to make disable/enable clock look
alike.

Signed-off-by: Stefan Agner <stefan@xxxxxxxx>
---
drivers/mmc/host/sdhci-esdhc-imx.c | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 85fd5a8b0b6d..aa48f4b2541a 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -708,14 +708,14 @@ static inline void esdhc_pltfm_set_clock(struct sdhci_host *host,
int div = 1;
u32 temp, val;

+ if (esdhc_is_usdhc(imx_data)) {
+ val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
+ writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
+ host->ioaddr + ESDHC_VENDOR_SPEC);
+ }
+
if (clock == 0) {
host->mmc->actual_clock = 0;
-
- if (esdhc_is_usdhc(imx_data)) {
- val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
- writel(val & ~ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
- host->ioaddr + ESDHC_VENDOR_SPEC);
- }
return;
}

@@ -761,7 +761,7 @@ static inline void esdhc_pltfm_set_clock(struct sdhci_host *host,
if (esdhc_is_usdhc(imx_data)) {
val = readl(host->ioaddr + ESDHC_VENDOR_SPEC);
writel(val | ESDHC_VENDOR_SPEC_FRC_SDCLK_ON,
- host->ioaddr + ESDHC_VENDOR_SPEC);
+ host->ioaddr + ESDHC_VENDOR_SPEC);
}

mdelay(1);
--
2.18.0