[PATCH v4 1/5] dt-bindings: w1: document generic onewire bindings

From: Daniel Mack
Date: Fri Jul 06 2018 - 01:37:12 EST


This patch adds a generic w1 bindings document that describes how w1
slave deviceses are grouped under master nodes. It also augments the
existing w1-gpio.txt document a bit.

Signed-off-by: Daniel Mack <daniel@xxxxxxxxxx>
---
.../devicetree/bindings/w1/w1-gpio.txt | 11 +++++---
Documentation/devicetree/bindings/w1/w1.txt | 25 +++++++++++++++++++
2 files changed, 33 insertions(+), 3 deletions(-)
create mode 100644 Documentation/devicetree/bindings/w1/w1.txt

diff --git a/Documentation/devicetree/bindings/w1/w1-gpio.txt b/Documentation/devicetree/bindings/w1/w1-gpio.txt
index 6e09c35d9f1a..3d6554eac240 100644
--- a/Documentation/devicetree/bindings/w1/w1-gpio.txt
+++ b/Documentation/devicetree/bindings/w1/w1-gpio.txt
@@ -13,10 +13,15 @@ Optional properties:
- linux,open-drain: if specified, the data pin is considered in
open-drain mode.

+Also refer to the generic w1.txt document.
+
Examples:

- onewire@0 {
+ onewire {
compatible = "w1-gpio";
- gpios = <&gpio 126 0>, <&gpio 105 0>;
- };
+ gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;

+ battery {
+ // ...
+ };
+ };
diff --git a/Documentation/devicetree/bindings/w1/w1.txt b/Documentation/devicetree/bindings/w1/w1.txt
new file mode 100644
index 000000000000..05f26b27d898
--- /dev/null
+++ b/Documentation/devicetree/bindings/w1/w1.txt
@@ -0,0 +1,25 @@
+Generic devicetree bindings for onewire (w1) busses
+===================================================
+
+Onewire busses are described through nodes of their master bus controller.
+Slave devices are listed as sub-nodes of such master devices. For now, only
+one slave is allowed per bus master.
+
+
+Example:
+
+ charger: charger {
+ compatible = "gpio-charger";
+ charger-type = "mains";
+ gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
+ };
+
+ onewire {
+ compatible = "w1-gpio";
+ gpios = <&gpio 100 0>, <&gpio 101 0>;
+
+ battery {
+ compatible = "maxim,ds2760";
+ power-supplies = <&charger>;
+ };
+ };
--
2.17.1