[PATCH 3/5] mtd: rawnand: qcom: fix NAND register write errors

[Abhishek Sahu]

Fix the following NAND register write errors which will
be generated if access protection is enabled.

1. SFLASHC_BURST_CFG register is not available for supported
   NAND contollers by this driver, so this can be removed.
2. NAND_CTRL is operational register and register writes to
   operational registers should always be done through
   command descriptors if BAM_MODE is already enabled.
   With full boot chain, bootloader already enables
   BAM_MODE so read the NAND_CTRL register value and write
   only if BAM_MODE is not set.

Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
---
 drivers/mtd/nand/raw/qcom_nandc.c | 11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index df12cf3..9e6b383 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -2693,15 +2693,20 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc)
 {
 	u32 nand_ctrl;
 
-	/* kill onenand */
-	nandc_write(nandc, SFLASHC_BURST_CFG, 0);
 	nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD),
 		    NAND_DEV_CMD_VLD_VAL);
 
 	/* enable ADM or BAM DMA */
 	if (nandc->props->is_bam) {
 		nand_ctrl = nandc_read(nandc, NAND_CTRL);
-		nandc_write(nandc, NAND_CTRL, nand_ctrl | BAM_MODE_EN);
+		/*
+		 * Once BAM_MODE_EN bit is set then QPIC_NAND_CTRL register
+		 * should be written with BAM instead of writel.
+		 * Check if BAM_MODE_EN is already set by bootloader and write
+		 * only if this bit is not set.
+		 */
+		if (!(nand_ctrl & BAM_MODE_EN))
+			nandc_write(nandc, NAND_CTRL, nand_ctrl | BAM_MODE_EN);
 	} else {
 		nandc_write(nandc, NAND_FLASH_CHIP_SELECT, DM_EN);
 	}
-- 
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc.
is a member of Code Aurora Forum, hosted by The Linux Foundation