Re: [PATCH 1/2] dt-bindings: media: i2c: Document MT9V111 bindings

[Sakari Ailus]

Hi Jacopo,

On Mon, Jun 11, 2018 at 05:17:32PM +0200, Jacopo Mondi wrote:
> Add documentation for Aptina MT9V111 image sensor.
> 
> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
> ---
>  .../bindings/media/i2c/aptina,mt9v111.txt          | 46 ++++++++++++++++++++++
>  1 file changed, 46 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
> 
> diff --git a/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
> new file mode 100644
> index 0000000..bac4bf0
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/i2c/aptina,mt9v111.txt
> @@ -0,0 +1,46 @@
> +* Aptina MT9V111 CMOS sensor
> +----------------------------
> +
> +The Aptina MT9V111 is a 1/4-Inch VGA-format digital image sensor with a core
> +based on Aptina MT9V011 sensor and an integrated Image Flow Processor (IFP).
> +
> +The sensor has an active pixel array of 649x489 pixels and can output a number

640x480 ?

> +of image resolution and formats controllable through a simple two-wires
> +interface.
> +
> +Required properties:
> +--------------------
> +
> +- compatible: shall be "aptina,mt9v111".
> +- clocks: reference to the system clock input provider.
> +
> +Optional properties:
> +--------------------
> +
> +- enable-gpios: output enable signal, pin name "OE#". Active low.
> +- standby-gpios: low power state control signal, pin name "STANDBY".
> +  Active high.
> +- reset-gpios: chip reset signal, pin name "RESET#". Active low.
> +
> +The device node must contain one 'port' child node with one 'endpoint' child
> +sub-node for its digital output video port, in accordance with the video
> +interface bindings defined in:
> +Documentation/devicetree/bindings/media/video-interfaces.txt
> +
> +Example:
> +--------
> +
> +        &i2c1 {
> +                camera@48 {
> +                        compatible = "aptina,mt9v111";
> +                        reg = <0x48>;
> +
> +                        clocks = <&camera_clk>;
> +
> +                        port {
> +                                mt9v111_out: endpoint {
> +                                        remote-endpoint = <&ceu_in>;
> +                                };
> +                        };
> +                };
> +        };

-- 
Sakari Ailus
e-mail: sakari.ailus@xxxxxx