Re: [PATCH 6/7] thunderbolt: Add support for runtime PM
From: Greg Kroah-Hartman
Date: Wed Jul 25 2018 - 04:17:07 EST
On Wed, Jul 25, 2018 at 11:03:20AM +0300, Mika Westerberg wrote:
> When Thunderbolt host controller is set to RTD3 mode (Runtime D3) it is
> present all the time. Because of this it is important to runtime suspend
> the controller whenever possible. In case of ICM we have following rules
> which all needs to be true before the host controller can be put to D3:
>
> - The controller firmware reports to support RTD3
> - All the connected devices announce support for RTD3
> - There is no active XDomain connection
>
> Implement this using standard Linux runtime PM APIs so that when all the
> children devices are runtime suspended, the Thunderbolt host controller
> PCI device is runtime suspended as well. The ICM firmware then starts
> powering down power domains towards RTD3 but it can prevent this if it
> detects that there is an active Display Port stream (this is not visible
> to the software, though).
>
> The Thunderbolt host controller will be runtime resumed either when
> there is a remote wake event (device is connected or disconnected), or
> when there is access from userspace that requires hardware access.
>
> Signed-off-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
> ---
> drivers/thunderbolt/domain.c | 42 +++++++++++-
> drivers/thunderbolt/icm.c | 119 ++++++++++++++++++++++++++++++----
> drivers/thunderbolt/nhi.c | 38 ++++++++++-
> drivers/thunderbolt/switch.c | 65 +++++++++++++++++--
> drivers/thunderbolt/tb.h | 10 +++
> drivers/thunderbolt/tb_msgs.h | 4 ++
> drivers/thunderbolt/xdomain.c | 18 +++++
> 7 files changed, 276 insertions(+), 20 deletions(-)
This patch did not apply to my tree at all, what branch did you make it
against?
I've applied the others here, thanks.
greg k-h