Thank you a lot for your comments,
I will fix these in the next version of the patch.
Jan
On
Thu, Jul 12, 2018 at 11:58:04AM +0000, Janek Kotas wrote:
This patch adds a device tree platform
driver description for Cadence UFS Controller.
Bindings
are not platform driversâ
OK, I will fix it.
Signed-off-by: Jan Kotas <jank@xxxxxxxxxxx>
---
.../devicetree/bindings/ufs/cdns,ufshc.txt | 31 ++++++++++++++++++++++
1 file changed, 31 insertions(+)
create mode 100644 Documentation/devicetree/bindings/ufs/cdns,ufshc.txt
diff --git a/Documentation/devicetree/bindings/ufs/cdns,ufshc.txt b/Documentation/devicetree/bindings/ufs/cdns,ufshc.txt
new file mode 100644
index 0000000..cb6d62a
--- /dev/null
+++ b/Documentation/devicetree/bindings/ufs/cdns,ufshc.txt
@@ -0,0 +1,31 @@
+* Cadence Universal Flash Storage (UFS) Controller
+
+UFS nodes are defined to describe on-chip UFS host controllers.
+Each UFS controller instance should have its own node.
+
+Required properties:
+- compatible : compatible list, contains the following controller:
+ "cdns,ufshc"
+ complemented with the JEDEC version:
+ "jedec,ufs-2.0"
+
+- reg : address and length of the UFS register set
+- interrupts : one interrupt mapping
+- clocks : List of phandle and clock specifier pairs.
+- clock-names : List of clock input name strings sorted in the same
+ order as the clocks property. "core" is mandatory.
And
phy?
It depends on a type of the PHY. Itâs not strictly needed by the driver.
In simulation and emulation, itâs possible to run a system without proper M-PHY.
I will clarify this.
+- freq-table-hz : Array of <min max> operating frequencies stored in the same
+ order as the clocks property. If this property is not
+ defined or a value in the array is "0" then it is assumed
+ that the frequency is set by the parent clock or a
+ fixed rate clock source.
Don't
define again here. Just refer to the common definition.
OK, I will change that.
+
+Example:
+ ufs@fd030000 {
+ compatible = "cdns,ufshc", "jedec,ufs-2.0";
+ reg = <0xfd030000 0x10000>;
+ interrupts = <0 1 IRQ_TYPE_LEVEL_HIGH>;
+ freq-table-hz = <0 0>, <0 0>;
+ clocks = <&ufs_core_clk>, <&ufs_phy_clk>;
+ clock-names = "core_clk", "phy_clk";
Doesnât
match the doc.
Thank you for spotting that, I will update the description.
|