On Mon, 30 Jul 2018 02:56:20 +0000 Matthew Leon <matthewleon@xxxxxxxxx> wrote:
> Hey Jisheng,
Hi,
>
In LKML, we'd better not top post.
> Shouldn't we be splitting until all DMA blocks are less than 128M boundary?
> I am a noob, but I think we should be prepared for boundaries that when
> split in two, will still be greater than 128M. Feel free to disagree but
> please explain why I may be wrong. Thank-you.
the limitation is "DMA addr can't span 128MB boundary" rather than "must be
less than 128MB", they are different.
And the max transfer size of one DMA desc is 64KB.
thanks
>
> Sincerely,
> Matthew Leon
>
> On Sun, Jul 29, 2018 at 10:46 PM, Jisheng Zhang <Jisheng.Zhang@xxxxxxxxxxxxx
> > wrote:Â
>
> > When using DMA, if the DMA addr spans 128MB boundary, we have to split
> > the DMA transfer into two so that each one doesn't exceed the boundary.
> >
> > Signed-off-by: Jisheng Zhang <Jisheng.Zhang@xxxxxxxxxxxxx>
> > ---
> >Â drivers/mmc/host/sdhci-of-dwcmshc.c | 43 +++++++++++++++++++++++++++++
> >Â 1 file changed, 43 insertions(+)
> >
> > diff --git a/drivers/mmc/host/sdhci-of-dwcmshc.c
> > b/drivers/mmc/host/sdhci-of-dwcmshc.c
> > index 1b7cd144fb01..e890fc8f5284 100644
> > --- a/drivers/mmc/host/sdhci-of-dwcmshc.c
> > +++ b/drivers/mmc/host/sdhci-of-dwcmshc.c
> > @@ -8,21 +8,52 @@
> >Â Â*/
> >
> >Â #include <linux/clk.h>
> > +#include <linux/mm.h>
> >Â #include <linux/module.h>
> >Â #include <linux/of.h>
> > +#include <linux/sizes.h>
> >
> >Â #include "sdhci-pltfm.h"
> >
> > +#define BOUNDARY_OK(addr, len) \
> > +Â Â Â Â((addr | (SZ_128M - 1)) == ((addr + len - 1) | (SZ_128M - 1)))
> > +
> >Â struct dwcmshc_priv {
> >    Âstruct clk   *bus_clk;
> >Â };
> >
> > +/*
> > + * if DMA addr spans 128MB boundary, we split the DMA transfer into two
> > + * so that the DMA transfer doesn't exceed the boundary.
> > + */
> > +static unsigned int dwcmshc_adma_write_desc(struct sdhci_host *host,
> > +Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Âvoid *desc, dma_addr_t addr,
> > +Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Âint len, unsigned int cmd)
> > +{
> > +Â Â Â Âint tmplen, offset;
> > +
> > +Â Â Â Âif (likely(!len || BOUNDARY_OK(addr, len)))
> > +Â Â Â Â Â Â Â Âreturn _sdhci_adma_write_desc(host, desc, addr, len, cmd);
> > +
> > +Â Â Â Âoffset = addr & (SZ_128M - 1);
> > +Â Â Â Âtmplen = SZ_128M - offset;
> > +Â Â Â Â_sdhci_adma_write_desc(host, desc, addr, tmplen, cmd);
> > +
> > +Â Â Â Âaddr += tmplen;
> > +Â Â Â Âlen -= tmplen;
> > +Â Â Â Âdesc += host->desc_sz;
> > +Â Â Â Â_sdhci_adma_write_desc(host, desc, addr, len, cmd);
> > +
> > +Â Â Â Âreturn host->desc_sz * 2;
> > +}
> > +
> >Â static const struct sdhci_ops sdhci_dwcmshc_ops = {
> >    Â.set_clock       = sdhci_set_clock,
> >    Â.set_bus_width     = sdhci_set_bus_width,
> >    Â.set_uhs_signaling   = sdhci_set_uhs_signaling,
> >    Â.get_max_clock     = sdhci_pltfm_clk_get_max_clock,
> >    Â.reset         = sdhci_reset,
> > +   Â.adma_write_desc    = dwcmshc_adma_write_desc,
> >Â };
> >
> >Â static const struct sdhci_pltfm_data sdhci_dwcmshc_pdata = {
> > @@ -36,12 +67,24 @@ static int dwcmshc_probe(struct platform_device *pdev)
> >Â Â Â Â Âstruct sdhci_host *host;
> >Â Â Â Â Âstruct dwcmshc_priv *priv;
> >Â Â Â Â Âint err;
> > +Â Â Â Âu32 extra;
> >
> >Â Â Â Â Âhost = sdhci_pltfm_init(pdev, &sdhci_dwcmshc_pdata,
> >Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â Âsizeof(struct dwcmshc_priv));
> >Â Â Â Â Âif (IS_ERR(host))
> >Â Â Â Â Â Â Â Â Âreturn PTR_ERR(host);
> >
> > +Â Â Â Â/*
> > +Â Â Â Â * The DMA descriptor table number is calculated as the maximum
> > +Â Â Â Â * number of segments times 2, to allow for an alignment
> > +Â Â Â Â * descriptor for each segment, plus 1 for a nop end descriptor,
> > +Â Â Â Â * plus extra number for cross 128M boundary handling.
> > +Â Â Â Â */
> > +Â Â Â Âextra = DIV_ROUND_UP(totalram_pages, SZ_128M / PAGE_SIZE);
> > +Â Â Â Âif (extra > SDHCI_MAX_SEGS)
> > +Â Â Â Â Â Â Â Âextra = SDHCI_MAX_SEGS;
> > +Â Â Â Âhost->adma_table_num = SDHCI_MAX_SEGS * 2 + 1 + extra;
> > +
> >Â Â Â Â Âpltfm_host = sdhci_priv(host);
> >Â Â Â Â Âpriv = sdhci_pltfm_priv(pltfm_host);
> >
> > --
> > 2.18.0
> >
> >Â