Re: [PATCH 07/10] dt-bindings: phy: add DT binding for Microsemi Ocelot SerDes muxing

[Florian Fainelli]

On 07/30/2018 05:43 AM, Quentin Schulz wrote:
> Signed-off-by: Quentin Schulz <quentin.schulz@xxxxxxxxxxx>
> ---
>  Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt | 42 +++++++-
>  1 file changed, 42 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt
> 
> diff --git a/Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt b/Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt
> new file mode 100644
> index 0000000..25b102d
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/phy/phy-ocelot-serdes.txt
> @@ -0,0 +1,42 @@
> +Microsemi Ocelot SerDes muxing driver
> +-------------------------------------
> +
> +On Microsemi Ocelot, there is a handful of registers in HSIO address
> +space for setting up the SerDes to switch port muxing.
> +
> +A SerDes X can be "muxed" to work with switch port Y or Z for example.
> +One specific SerDes can also be used as a PCIe interface.
> +
> +Hence, a SerDes represents an interface, be it an Ethernet or a PCIe one.
> +
> +There are two kinds of SerDes: SERDES1G supports 10/100Mbps in
> +half/full-duplex and 1000Mbps in full-duplex mode while SERDES6G supports
> +10/100Mbps in half/full-duplex and 1000/2500Mbps in full-duplex mode.
> +
> +Also, SERDES6G number (aka "macro") 0 is the only interface supporting
> +QSGMII.
> +
> +Required properties:
> +
> +- compatible: should be "mscc,vsc7514-serdes"
> +- #phy-cells : from the generic phy bindings, must be 3. The first number
> +               defines the kind of Serdes (1 for SERDES1G_X, 6 for
> +	       SERDES6G_X), the second defines the macros in the specified
> +	       kind of Serdes (X for SERDES1G_X or SERDES6G_X) and the
> +	       last one defines the input port to use for a given SerDes
> +	       macro,

It would probably be more natural to reverse some of this and have the
1st cell be the input port, while the 2nd and 3rd cell are the serdes
kind and the serdes macro type. Same comment as Andrew, can you please
define the 2nd and 3rd cells possible values in a header file that you
can include from both the DTS and the driver making use of that?
-- 
Florian