[PATCH 18/40] mmc: tegra: Perform pad calibration after voltage switch

[Aapo Vienamo]

Run the automatic pad calibration after voltage switching if
tegra_host->pad_calib_required is set.

Signed-off-by: Aapo Vienamo <avienamo@xxxxxxxxxx>
---
 drivers/mmc/host/sdhci-tegra.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
index 681987e..2b87f3a4 100644
--- a/drivers/mmc/host/sdhci-tegra.c
+++ b/drivers/mmc/host/sdhci-tegra.c
@@ -571,6 +571,8 @@ static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc,
 						   struct mmc_ios *ios)
 {
 	struct sdhci_host *host = mmc_priv(mmc);
+	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+	struct sdhci_tegra *tegra_host = sdhci_pltfm_priv(pltfm_host);
 	int ret = 0;
 
 	if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330) {
@@ -585,6 +587,9 @@ static int sdhci_tegra_start_signal_voltage_switch(struct mmc_host *mmc,
 		ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage);
 	}
 
+	if (tegra_host->pad_calib_required)
+		tegra_sdhci_pad_autocalib(host);
+
 	return ret;
 }
 
-- 
2.7.4