Re: [PATCH v5 1/2] leds: core: Introduce LED pattern trigger

[Jacek Anaszewski]

Hi Baolin,

On 08/09/2018 07:48 AM, Baolin Wang wrote:
[...]
>>>>> +static int pattern_trig_start_pattern(struct pattern_trig_data *data,
>>>>> +                                   struct led_classdev *led_cdev)
>>>>> +{
>>>>> +     if (!data->npatterns)
>>>>> +             return 0;
>>>>> +
>>>>> +     if (led_cdev->pattern_set) {
>>>>> +             return led_cdev->pattern_set(led_cdev, data->patterns,
>>>>> +                                          data->npatterns, data->repeat);
>>>>
>>>> I think that it would be more flexible if software pattern fallback
>>>> was applied in case of pattern_set failure. Otherwise, it would
>>>> lead to the situation where LED class devices that support hardware
>>>> blinking couldn't be applied the same set of patterns as LED class
>>>> devices that don't implement pattern_set. The latter will always have to
>>>> resort to using software pattern engine which will accept far greater
>>>> amount of pattern combinations.
>>>
>>> Hmmm, I am not sure this is useful for hardware pattern, since the LED
>>> hardware can be diverse which is hard to be compatible with software
>>> pattern.
>>>
>>> For example, for our SC27XX LED, it only supports 4 hardware patterns
>>> setting (low time, rising time, high time and falling time) to make it
>>> work at breathing mode. If user provides 3 or 5 patterns values, it
>>> will failed to issue pattern_set(). But at this time, we don't want to
>>> use software pattern instead since it will be not the breathing mode
>>> expected by user. I don't know if there are other special LED
>>> hardware.
>>
>> Good point. So this is the issue we should dwell on, since the
>> requested pattern effect should look similar on all devices.
>> Of course in case of software pattern it will be often impossible
>> to achieve the same fluency. Similarly as in case of rendering graphics
>> with and without acceleration.
>>
>> In case of your device, I'd say that we'd need more complex description
>> of breathing mode pattern. More complex than just four intervals.
>> It should reflect all the intervals the hardware engine needs to perform
>> to achieve the breathing effect. Can this information be inferred from
>> the docs?
> 
>>From our docs, it only provides registers to set the low time, rising
> time, high time and falling time (value unit is 0.125s and max value
> is 63 = 7.875s) to enable breathing mode. So each interval value can
> be 1 ~ 63. But that is still hard for software pattern to simulate the
> breathing mode performed by hardware pattern.

Software fallback is not expected to show similar performance to the
hardware engine on the whole span of the supported time range.

Having min rise time value at 125ms, and given that max_brightness
is 255, then we'd have 255 / 125 = 2.04 of brightness level rise per
1ms. So, the pattern for rising edge could look like (assuming we
stop at 254):

0 1 2 1 4 1 6 1 8 1 10 1 ... 254 1

Now, I'm starting to wonder if we shouldn't have specialized trigger
for breathing patterns, that would accept brightness level change per
time period. Pattern trigger needs more flexibility and inferring if the
hardware can handle given series of pattern intervals would entail
unnecessary code complexity.

Such breathing trigger would require triplets comprised of
start brightness, end brightness and a duration of the brightness
transition.

-- 
Best regards,
Jacek Anaszewski