[PATCH v2 2/2] drm/atmel-hlcdc: allow selecting a higher pixel-clock than requested

From: Peter Rosin
Date: Fri Aug 24 2018 - 05:25:30 EST


But only if the highest pixel-clock frequency lower than requested
is significantly less accurate than the lowest frequency higher than
requested.

I pulled "10 times" as the discriminator out of the hat, and went with
that.

This is useful, if e.g. the target pixel-clock is 65MHz and the sys_clk
is 132MHz. In this case the highest possible pixel-clock lower than the
requested 65MHz is 52.8MHz, which is almost 20% off (and outside the
spec for the panel). The lowest possible pixel-clock higher than 65MHz
is 66MHz, which is a *much* better match, and only 1.5% off.

Signed-off-by: Peter Rosin <peda@xxxxxxxxxx>
---
drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c | 12 ++++++++++++
1 file changed, 12 insertions(+)

diff --git a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
index 0d9d1042752a..9e34bce089d0 100644
--- a/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
+++ b/drivers/gpu/drm/atmel-hlcdc/atmel_hlcdc_crtc.c
@@ -116,6 +116,18 @@ static void atmel_hlcdc_crtc_mode_set_nofb(struct drm_crtc *c)
div = DIV_ROUND_UP(prate, mode_rate);
if (ATMEL_HLCDC_CLKDIV(div) & ~ATMEL_HLCDC_CLKDIV_MASK)
div = ATMEL_HLCDC_CLKDIV_MASK;
+ } else {
+ int div_low = prate / mode_rate;
+
+ if (div_low >= 2 &&
+ ((prate / div_low - mode_rate) <
+ 10 * (mode_rate - prate / div)))
+ /*
+ * At least 10 times better when using a higher
+ * frequency than requested, instead of a lower.
+ * So, go with that.
+ */
+ div = div_low;
}

cfg |= ATMEL_HLCDC_CLKDIV(div);
--
2.11.0