Re: [PATCH v5 3/3] mmc: sdhci-of-dwcmshc: solve 128MB DMA boundary limitation

[Adrian Hunter]

On 27/08/18 11:24, Jisheng Zhang wrote:
> When using DMA, if the DMA addr spans 128MB boundary, we have to split
> the DMA transfer into two so that each one doesn't exceed the boundary.
> 
> Signed-off-by: Jisheng Zhang <Jisheng.Zhang@xxxxxxxxxxxxx>
> ---
>  drivers/mmc/host/sdhci-of-dwcmshc.c | 41 +++++++++++++++++++++++++++++
>  1 file changed, 41 insertions(+)
> 
> diff --git a/drivers/mmc/host/sdhci-of-dwcmshc.c b/drivers/mmc/host/sdhci-of-dwcmshc.c
> index 1b7cd144fb01..cfbdae8703a1 100644
> --- a/drivers/mmc/host/sdhci-of-dwcmshc.c
> +++ b/drivers/mmc/host/sdhci-of-dwcmshc.c
> @@ -8,21 +8,50 @@
>   */
>  
>  #include <linux/clk.h>
> +#include <linux/mm.h>
>  #include <linux/module.h>
>  #include <linux/of.h>
> +#include <linux/sizes.h>
>  
>  #include "sdhci-pltfm.h"
>  
> +#define BOUNDARY_OK(addr, len) \
> +	((addr | (SZ_128M - 1)) == ((addr + len - 1) | (SZ_128M - 1)))
> +
>  struct dwcmshc_priv {
>  	struct clk	*bus_clk;
>  };
>  
> +/*
> + * If DMA addr spans 128MB boundary, we split the DMA transfer into two
> + * so that each DMA transfer doesn't exceed the boundary.
> + */
> +static void dwcmshc_adma_write_desc(struct sdhci_host *host, void **desc,
> +				    dma_addr_t addr, int len, unsigned int cmd)
> +{
> +	int tmplen, offset;
> +
> +	if (likely(!len || BOUNDARY_OK(addr, len))) {
> +		sdhci_adma_write_desc(host, desc, addr, len, cmd);
> +		return;
> +	}
> +
> +	offset = addr & (SZ_128M - 1);
> +	tmplen = SZ_128M - offset;
> +	sdhci_adma_write_desc(host, desc, addr, tmplen, cmd);
> +
> +	addr += tmplen;
> +	len -= tmplen;
> +	sdhci_adma_write_desc(host, desc, addr, len, cmd);
> +}
> +
>  static const struct sdhci_ops sdhci_dwcmshc_ops = {
>  	.set_clock		= sdhci_set_clock,
>  	.set_bus_width		= sdhci_set_bus_width,
>  	.set_uhs_signaling	= sdhci_set_uhs_signaling,
>  	.get_max_clock		= sdhci_pltfm_clk_get_max_clock,
>  	.reset			= sdhci_reset,
> +	.adma_write_desc	= dwcmshc_adma_write_desc,
>  };
>  
>  static const struct sdhci_pltfm_data sdhci_dwcmshc_pdata = {
> @@ -36,12 +65,24 @@ static int dwcmshc_probe(struct platform_device *pdev)
>  	struct sdhci_host *host;
>  	struct dwcmshc_priv *priv;
>  	int err;
> +	u32 extra;
>  
>  	host = sdhci_pltfm_init(pdev, &sdhci_dwcmshc_pdata,
>  				sizeof(struct dwcmshc_priv));
>  	if (IS_ERR(host))
>  		return PTR_ERR(host);
>  
> +	/*
> +	 * The DMA table descriptor count is calculated as the maximum
> +	 * number of segments times 2, to allow for an alignment
> +	 * descriptor for each segment, plus 1 for a nop end descriptor,
> +	 * plus extra number for cross 128M boundary handling.
> +	 */
> +	extra = DIV_ROUND_UP(totalram_pages, SZ_128M / PAGE_SIZE);

The amount of RAM is not necessarily the same as the highest physical
address.  I think what you really want is max_pfn or max_possible_pfn

> +	if (extra > SDHCI_MAX_SEGS)
> +		extra = SDHCI_MAX_SEGS;
> +	host->adma_table_cnt += extra;
> +
>  	pltfm_host = sdhci_priv(host);
>  	priv = sdhci_pltfm_priv(pltfm_host);
>  
>