Re: [PATCH V8 7/9] mmc: sdhci: SDMA may use Auto-CMD23 in v4 mode

[Adrian Hunter]

On 30/08/18 11:21, Chunyan Zhang wrote:
> When Host Version 4 Enable is set to 1, SDMA uses ADMA System Address
> register (05Fh-058h) instead of using register (000h-004h) to indicate
> its system address of data location. The register (000h-004h) is
> re-assigned to 32-bit Block Count and Auto CMD23 argument, so then SDMA
> may use Auto CMD23.
> 
> Signed-off-by: Chunyan Zhang <zhang.chunyan@xxxxxxxxxx>

Acked-by: Adrian Hunter <adrian.hunter@xxxxxxxxx>

> ---
>  drivers/mmc/host/sdhci.c | 7 +++++--
>  1 file changed, 5 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> index 62d843ac90..606d331 100644
> --- a/drivers/mmc/host/sdhci.c
> +++ b/drivers/mmc/host/sdhci.c
> @@ -3834,10 +3834,13 @@ int sdhci_setup_host(struct sdhci_host *host)
>  	if (host->quirks & SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12)
>  		host->flags |= SDHCI_AUTO_CMD12;
>  
> -	/* Auto-CMD23 stuff only works in ADMA or PIO. */
> +	/*
> +	 * For v3 mode, Auto-CMD23 stuff only works in ADMA or PIO.
> +	 * For v4 mode, SDMA may use Auto-CMD23 as well.
> +	 */
>  	if ((host->version >= SDHCI_SPEC_300) &&
>  	    ((host->flags & SDHCI_USE_ADMA) ||
> -	     !(host->flags & SDHCI_USE_SDMA)) &&
> +	     !(host->flags & SDHCI_USE_SDMA) || host->v4_mode) &&
>  	     !(host->quirks2 & SDHCI_QUIRK2_ACMD23_BROKEN)) {
>  		host->flags |= SDHCI_AUTO_CMD23;
>  		DBG("Auto-CMD23 available\n");
>