Re: [PATCH tip/core/rcu 3/3] srcu: Make early-boot call_srcu() reuse workqueue lists

[Steven Rostedt]

On Thu, 30 Aug 2018 17:09:52 -0700
"Paul E. McKenney" <paulmck@xxxxxxxxxxxxxxxxxx> wrote:

> On Thu, Aug 30, 2018 at 07:53:22PM -0400, Steven Rostedt wrote:
> > On Thu, 30 Aug 2018 16:12:11 -0700
> > "Paul E. McKenney" <paulmck@xxxxxxxxxxxxxxxxxx> wrote:
> > 
> >   
> > > > > -	WARN_ON_ONCE(rcu_scheduler_active == RCU_SCHEDULER_INIT);    
> > > > 
> > > > Well it boots without warning ;-)
> > > > 
> > > > Tested-by: Steven Rostedt (VMware) <rostedt@xxxxxxxxxxx>    
> > > 
> > > Thank you again!  I applied this to 1/3 and 3/3 on the assumption that
> > > you did not run rcutorture.  ;-)  
> > 
> > No rcutorture. Just reverted the tracepoint SRCU delay patch and it
> > boots with the trace event enabled.  
> 
> Very good, then I did get it right.  1/3 and 3/3, but not 2/3.
>

I did apply 2, but didn't enable rcutorture. I just applied the entire
series.

-- Steve