Re: [PATCH v2 0/8] Tegra SDHCI support HS400 on Tegra210 and Tegra186
From: Ulf Hansson
Date: Mon Sep 03 2018 - 02:14:22 EST
On 10 August 2018 at 20:13, Aapo Vienamo <avienamo@xxxxxxxxxx> wrote:
> Hi all,
> This series implements support for HS400 signaling on Tegra210 and
> Tegra186. This includes programming the DQS trimmer values, implementing
> enhanced strobe and HS400 delay line calibration.
>
> This series depends on the "Tegra SDHCI add support for HS200 and UHS
> signaling" series.
>
> Changelog:
> v2:
> - Document in dt-bindings which controllers support HS400
> - Use val instead of reg in tegra_sdhci_set_dqs_trim()
> - Change "dt" to "DT" in "mmc: tegra: Parse and program DQS trim
> value" commit message
> - Add spaces around << in tegra_sdhci_set_dqs_trim()
> - Make the "mmc: tegra: Implement HS400 enhanced strobe" commit
> message more detailed
> - Remove a debug print from tegra_sdhci_hs400_enhanced_strobe()
> - Add blank lines around if-else-block in
> tegra_sdhci_hs400_enhanced_strobe()
> - Use val instead of reg in tegra_sdhci_hs400_enhanced_strobe()
> - Make commit message of "mmc: tegra: Implement HS400 delay line
> calibration" more detailed
>
> Aapo Vienamo (8):
> dt-bindings: mmc: Add DQS trim value to Tegra SDHCI
> mmc: tegra: Parse and program DQS trim value
> mmc: tegra: Implement HS400 enhanced strobe
> mmc: tegra: Implement HS400 delay line calibration
> arm64: dts: tegra186: Add SDMMC4 DQS trim value
> arm64: dts: tegra210: Add SDMMC4 DQS trim value
> arm64: dts: tegra186: Enable HS400
> arm64: dts: tegra210: Enable HS400
>
> .../bindings/mmc/nvidia,tegra20-sdhci.txt | 4 ++
> arch/arm64/boot/dts/nvidia/tegra186.dtsi | 2 +
> arch/arm64/boot/dts/nvidia/tegra210.dtsi | 2 +
> drivers/mmc/host/sdhci-tegra.c | 84 +++++++++++++++++++++-
> 4 files changed, 89 insertions(+), 3 deletions(-)
>
> --
> 2.7.4
>
Applied patch 1->4 for next, thanks!
Kind regards
Uffe