RE: [PATCH 2/2] tty: serial: imx: add pinctrl sleep/default mode switch for suspend

[Anson Huang]

Gentle Ping...

Anson Huang
Best Regards!


> -----Original Message-----
> From: Anson Huang
> Sent: Thursday, August 9, 2018 6:06 PM
> To: gregkh@xxxxxxxxxxxxxxxxxxx; jslaby@xxxxxxxx;
> linux-serial@xxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> Cc: dl-linux-imx <linux-imx@xxxxxxx>
> Subject: [PATCH 2/2] tty: serial: imx: add pinctrl sleep/default mode switch for
> suspend
> 
> On some i.MX SoCs' low power mode, UART iomux settings may be lost, need
> to add pinctrl sleep/default mode switch during suspend/resume to make sure
> UART iomux settings are correct after resume.
> 
> Signed-off-by: Anson Huang <Anson.Huang@xxxxxxx>
> ---
>  drivers/tty/serial/imx.c | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c index
> a09ccef..c280d43 100644
> --- a/drivers/tty/serial/imx.c
> +++ b/drivers/tty/serial/imx.c
> @@ -24,6 +24,7 @@
>  #include <linux/serial.h>
>  #include <linux/clk.h>
>  #include <linux/delay.h>
> +#include <linux/pinctrl/consumer.h>
>  #include <linux/rational.h>
>  #include <linux/slab.h>
>  #include <linux/of.h>
> @@ -2447,6 +2448,8 @@ static int imx_uart_suspend_noirq(struct device
> *dev)
> 
>  	clk_disable(sport->clk_ipg);
> 
> +	pinctrl_pm_select_sleep_state(dev);
> +
>  	return 0;
>  }
> 
> @@ -2455,6 +2458,8 @@ static int imx_uart_resume_noirq(struct device
> *dev)
>  	struct imx_port *sport = dev_get_drvdata(dev);
>  	int ret;
> 
> +	pinctrl_pm_select_default_state(dev);
> +
>  	ret = clk_enable(sport->clk_ipg);
>  	if (ret)
>  		return ret;
> --
> 2.7.4