Re: [PATCH v3 27/30] ARM: dts: sun8i: h3: use calibration for ths

[Emmanuel Vadot]

 Hi Philipp,

On Thu, 30 Aug 2018 17:45:15 +0200
Philipp Rossak <embed3d@xxxxxxxxx> wrote:

> The H3 SID is supported by the kernel so we can add a NVMEM Data cell,
> that contains the calibration data.
> 
> On the H3 the eFuses are located at the offset 0x200. The thermal data
> itself has an offset of 0x34 from the eFuse base. So we end on an offset
> of 0x234.
> 
> Signed-off-by: Philipp Rossak <embed3d@xxxxxxxxx>
> ---
>  arch/arm/boot/dts/sun8i-h3.dtsi | 9 +++++++++
>  1 file changed, 9 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/sun8i-h3.dtsi b/arch/arm/boot/dts/sun8i-h3.dtsi
> index 1866aec69ec1..0fc447f0c02a 100644
> --- a/arch/arm/boot/dts/sun8i-h3.dtsi
> +++ b/arch/arm/boot/dts/sun8i-h3.dtsi
> @@ -106,8 +106,15 @@
>  
>  	soc {
>  		sid: eeprom@1c14000 {
> +			#address-cells = <1>;
> +			#size-cells = <1>;
>  			compatible = "allwinner,sun8i-h3-sid";
>  			reg = <0x01c14000 0x400>;
> +
> +			/* Data cells */
> +			thermal_calibration: calib@234 {
> +				reg = <0x234 0x8>;
> +			};

 You are declaring 8 bytes of calibration data but to my knowledge it's
only 2 bytes per sensor, so 2 bytes for H3.
 Am I missing something ?

 Thanks,
>  		};
>  	};
>  
> @@ -227,4 +234,6 @@
>  &ths {
>  	compatible = "allwinner,sun8i-h3-ths";
>  	#thermal-sensor-cells = <0>;
> +	nvmem-cells = <&thermal_calibration>;
> +	nvmem-cell-names = "calibration";
>  };
> -- 
> 2.11.0
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel


-- 
Emmanuel Vadot <manu@xxxxxxxxxxxxxxxx> <manu@xxxxxxxxxxx>