Re: [PATCH] mtd: rawnand: denali: add DT property to specify skipped bytes in OOB

[Boris Brezillon]

Hi Masahiro,

On Fri,  7 Sep 2018 19:56:23 +0900
Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> wrote:

> NAND devices need additional data area (OOB) for error correction,
> but it is also used for Bad Block Marker (BBM).  In many cases, the
> first byte in OOB is used for BBM, but the location actually depends
> on chip vendors.  The NAND controller should preserve the precious
> BBM to keep track of bad blocks.
> 
> In Denali IP, the SPARE_AREA_SKIP_BYTES register is used to specify
> the number of bytes to skip from the start of OOB.  The ECC engine
> will automatically skip the specified number of bytes when it gets
> access to OOB area.
> 
> The same value for SPARE_AREA_SKIP_BYTES should be used between
> firmware and the operating system if you intend to use the NAND
> device across the control hand-off.
> 
> In fact, the current denali.c code expects firmware to have already
> set the SPARE_AREA_SKIP_BYTES register, then reads the value out.
> 
> If no firmware (or bootloader) has initialized the controller, the
> register value is zero, which is the default after power-on-reset.
> 
> In other words, the Linux driver cannot initialize the controller
> by itself.  You cannot support the reset control either because
> resetting the controller will get register values lost.
> 
> This commit adds a way to specify it via DT.  If the property
> "denali,oob-skip-bytes" exists, the value will be set to the register.

Hm, do we really need to make this config customizable? I mean, either
you have a large-page NAND (page > 512 bytes) and the 2 first bytes
must be reserved for the BBM or you have a small-page NAND and the BBM
is at position 4 and 5. Are you sure people configure that differently?
Don't you always have SPARE_AREA_SKIP_BYTES set to 6 or 2?

Regards,

Boris