[PATCH 0/3] mtd: rawnand: add STM32 FMC2 NAND flash controller driver

[christophe.kerello]

From: Christophe Kerello <christophe.kerello@xxxxxx>

This patchset adds the support for the STMicroelectronics FMC2 NAND flash
controller found on STM32MP SOCs.

This patchset supports:
  - the command sequencer feature, a hardware accelerator for read/write
    within a page
  - the manual mode feature, useful for debug purpose
  - a maximum 8k page size
  - following ECC strength and step size
	- nand-ecc-strength = <8>, nand-ecc-step-size = <512> (BCH8)
	- nand-ecc-strength = <4>, nand-ecc-step-size = <512> (BCH4)
	- nand-ecc-strength = <1>, nand-ecc-step-size = <512> (Extended ecc
	  based on HAMMING)
    
This patchset has been tested on Micron MT29F8G08ABACAH4 (8-bit SLC NAND)
and MT29F8G16ABACAH4 (16-bit SLC NAND)

Christophe Kerello (3):
  dt-bindings: mtd: stm32_fmc2: add STM32 FMC2 NAND controller
    documentation
  mtd: rawnand: stm32_fmc2: add STM32 FMC2 NAND flash controller driver
  mtd: rawnand: stm32_fmc2: add manual mode

 .../devicetree/bindings/mtd/stm32-fmc2-nand.txt    |   90 +
 drivers/mtd/nand/raw/Kconfig                       |    9 +
 drivers/mtd/nand/raw/Makefile                      |    1 +
 drivers/mtd/nand/raw/stm32_fmc2_nand.c             | 1980 ++++++++++++++++++++
 4 files changed, 2080 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mtd/stm32-fmc2-nand.txt
 create mode 100644 drivers/mtd/nand/raw/stm32_fmc2_nand.c

-- 
1.9.1