[PATCH 2/5] mm/memory_hotplug: Avoid node_set/clear_state(N_HIGH_MEMORY) when !CONFIG_HIGHMEM

[Oscar Salvador]

From: Oscar Salvador <osalvador@xxxxxxx>

Currently, when !CONFIG_HIGHMEM, status_change_nid_high is being set
to status_change_nid_normal, but on such systems N_HIGH_MEMORY falls
back to N_NORMAL_MEMORY.
That means that if status_change_nid_normal is not -1,
we will perform two calls to node_set_state for the same memory type.

Set status_change_nid_high to -1 for !CONFIG_HIGHMEM, so we skip the
double call in node_states_set_node.

The same goes for node_clear_state.

Signed-off-by: Oscar Salvador <osalvador@xxxxxxx>
---
 mm/memory_hotplug.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)

diff --git a/mm/memory_hotplug.c b/mm/memory_hotplug.c
index 63facfc57224..c2c7359bd0a7 100644
--- a/mm/memory_hotplug.c
+++ b/mm/memory_hotplug.c
@@ -731,7 +731,11 @@ static void node_states_check_changes_online(unsigned long nr_pages,
 	else
 		arg->status_change_nid_high = -1;
 #else
-	arg->status_change_nid_high = arg->status_change_nid_normal;
+	/*
+	 * When !CONFIG_HIGHMEM, N_HIGH_MEMORY equals N_NORMAL_MEMORY
+	 * so setting the node for N_NORMAL_MEMORY is enough.
+	 */
+	arg->status_change_nid_high = -1;
 #endif
 
 	/*
@@ -1555,7 +1559,11 @@ static void node_states_check_changes_offline(unsigned long nr_pages,
 	else
 		arg->status_change_nid_high = -1;
 #else
-	arg->status_change_nid_high = arg->status_change_nid_normal;
+	/*
+	 * When !CONFIG_HIGHMEM, N_HIGH_MEMORY equals N_NORMAL_MEMORY
+	 * so clearing the node for N_NORMAL_MEMORY is enough.
+	 */
+	arg->status_change_nid_high = -1;
 #endif
 
 	/*
-- 
2.13.6