Re: [PATCH] mmc: add quirk for O2 Micro dev 0x8620 rev 0x01

[Yu Zhao]

On Thu, Sep 27, 2018 at 01:48:58AM +0200, Ulf Hansson wrote:
> On 23 September 2018 at 22:39, Yu Zhao <yuzhao@xxxxxxxxxx> wrote:
> > This device reports SDHCI_CLOCK_INT_STABLE even though it's not
> > ready to take SDHCI_CLOCK_CARD_EN. The symptom is that reading
> > SDHCI_CLOCK_CONTROL after enabling the clock shows absence of the
> > bit from the register (e.g. expecting 0x0000fa07 = 0x0000fa03 |
> > SDHCI_CLOCK_CARD_EN but only observed the first operand).
> >
> > mmc1: Timeout waiting for hardware cmd interrupt.
> > mmc1: sdhci: ============ SDHCI REGISTER DUMP ===========
> > mmc1: sdhci: Sys addr:  0x00000000 | Version:  0x00000603
> > mmc1: sdhci: Blk size:  0x00000000 | Blk cnt:  0x00000000
> > mmc1: sdhci: Argument:  0x00000000 | Trn mode: 0x00000000
> > mmc1: sdhci: Present:   0x01ff0001 | Host ctl: 0x00000001
> > mmc1: sdhci: Power:     0x0000000f | Blk gap:  0x00000000
> > mmc1: sdhci: Wake-up:   0x00000000 | Clock:    0x0000fa03
> > mmc1: sdhci: Timeout:   0x00000000 | Int stat: 0x00000000
> > mmc1: sdhci: Int enab:  0x00ff0083 | Sig enab: 0x00ff0083
> > mmc1: sdhci: AC12 err:  0x00000000 | Slot int: 0x00000000
> > mmc1: sdhci: Caps:      0x25fcc8bf | Caps_1:   0x00002077
> > mmc1: sdhci: Cmd:       0x00000000 | Max curr: 0x005800c8
> > mmc1: sdhci: Resp[0]:   0x00000000 | Resp[1]:  0x00000000
> > mmc1: sdhci: Resp[2]:   0x00000000 | Resp[3]:  0x00000000
> > mmc1: sdhci: Host ctl2: 0x00000008
> > mmc1: sdhci: ADMA Err:  0x00000000 | ADMA Ptr: 0x00000000
> > mmc1: sdhci: ============================================
> >
> > The problem happens during wakeup from S3. Adding a delay quirk
> > after power up reliably fixes the problem.
> >
> > Signed-off-by: Yu Zhao <yuzhao@xxxxxxxxxx>
> 
> Applied for next, thanks!
> 
> Kind regards
> Uffe
> 
> > ---
> >  drivers/mmc/host/sdhci-pci-o2micro.c | 2 ++
> >  1 file changed, 2 insertions(+)
> >
> > diff --git a/drivers/mmc/host/sdhci-pci-o2micro.c b/drivers/mmc/host/sdhci-pci-o2micro.c
> > index 77e9bc4aaee9..3e5ecf7ce101 100644
> > --- a/drivers/mmc/host/sdhci-pci-o2micro.c
> > +++ b/drivers/mmc/host/sdhci-pci-o2micro.c
> > @@ -490,6 +490,8 @@ int sdhci_pci_o2_probe(struct sdhci_pci_chip *chip)
> >                 pci_write_config_byte(chip->pdev, O2_SD_LOCK_WP, scratch);
> >                 break;
> >         case PCI_DEVICE_ID_O2_SEABIRD0:
> > +               if (chip->pdev->revision == 0x01)
> > +                       chip->quirks |= SDHCI_QUIRK_DELAY_AFTER_POWER;

Hi Uffe,

I apologize for the missing /* fall through */ here. Could you
please add it in case it causes any static checker problem?
Or I can send a v2.

Thank you.