Re: [PATCH V6 08/33] csky: Process management and Signal

[Guo Ren]

On Thu, Sep 27, 2018 at 09:50:43PM +0200, Eric W. Biederman wrote:
> Guo Ren <ren_guo@xxxxxxxxx> writes:
> 
> > --- /dev/null
> > +++ b/arch/csky/abiv2/fpu.c
> > +void fpu_fpe(struct pt_regs * regs)
> > +{
> > +	int sig;
> > +	unsigned int fesr;
> > +	siginfo_t info;
> > +
> > +	fesr = mfcr("cr<2, 2>");
> > +
> > +	if(fesr & FPE_ILLE){
> > +		info.si_code = ILL_ILLOPC;
> > +		sig = SIGILL;
> > +	}
> > +	else if(fesr & FPE_IDC){
> > +		info.si_code = ILL_ILLOPN;
> > +		sig = SIGILL;
> > +	}
> > +	else if(fesr & FPE_FEC){
> > +		sig = SIGFPE;
> > +		if(fesr & FPE_IOC){
> > +			info.si_code = FPE_FLTINV;
> > +		}
> > +		else if(fesr & FPE_DZC){
> > +			info.si_code = FPE_FLTDIV;
> > +		}
> > +		else if(fesr & FPE_UFC){
> > +			info.si_code = FPE_FLTUND;
> > +		}
> > +		else if(fesr & FPE_OFC){
> > +			info.si_code = FPE_FLTOVF;
> > +		}
> > +		else if(fesr & FPE_IXC){
> > +			info.si_code = FPE_FLTRES;
> > +		}
> > +		else {
> > +			info.si_code = NSIGFPE;
> > +		}
> > +	}
> > +	else {
> > +		info.si_code = NSIGFPE;
> > +		sig = SIGFPE;
> > +	}
> > +	info.si_signo = SIGFPE;
> > +	info.si_errno = 0;
> > +	info.si_addr = (void *)regs->pc;
> > +	force_sig_info(sig, &info, current);
> > +}
> 
> 
> This use of sending a signal is buggy.  It results in undefined values
> being copied to userspace.
> 
> Userspace should never be sent NSIGXXX as a si_code.  You can use
> FPE_FLTUNK for this default case.
> 
> In new code please use force_sig_fault instead of force_sig_info in new
> code.  That saves you the trouble of messing with struct siginfo.
Ok, I'll check and USE FPE_FLTUNK and force_sig_fault instead.

Best Regards
 Guo Ren