Re: [PATCH v2] i2c: brcmstb: Allow enabling the driver on DSL SoCs

[Andy Shevchenko]

On Mon, Oct 1, 2018 at 8:44 PM Florian Fainelli <f.fainelli@xxxxxxxxx> wrote:
>
> ARCH_BCM_63XX which is used by ARM-based DSL SoCs from Broadcom uses the
> same controller, make it possible to select the STB driver and update
> the Kconfig and help text a bit.
>
> Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
> ---
> Changes in v2:
>
> - Make COMPILE_TEST last, as per Geert's recommendation
>
>  drivers/i2c/busses/Kconfig | 7 ++++---
>  1 file changed, 4 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/i2c/busses/Kconfig b/drivers/i2c/busses/Kconfig
> index 451d4ae50e66..56ccb1ea7da5 100644
> --- a/drivers/i2c/busses/Kconfig
> +++ b/drivers/i2c/busses/Kconfig
> @@ -432,12 +432,13 @@ config I2C_BCM_KONA
>           If you do not need KONA I2C interface, say N.
>
>  config I2C_BRCMSTB
> -       tristate "BRCM Settop I2C controller"
> -       depends on ARCH_BRCMSTB || BMIPS_GENERIC || COMPILE_TEST
> +       tristate "BRCM Settop/DSL I2C controller"
> +       depends on ARCH_BRCMSTB || BMIPS_GENERIC || ARCH_BCM_63XX || \
> +                  COMPILE_TEST

I would rather split this to two 'depends' entries, though it's
cosmetic and up to you.

>         default y
>         help
>           If you say yes to this option, support will be included for the
> -         I2C interface on the Broadcom Settop SoCs.
> +         I2C interface on the Broadcom Settop/DSL SoCs.
>
>           If you do not need I2C interface, say N.
>
> --
> 2.17.1
>


-- 
With Best Regards,
Andy Shevchenko