Re: [PATCH v3 1/2] [media] imx214: device tree binding

[Sakari Ailus]

Hi Laurent,

On Tue, Oct 02, 2018 at 04:47:55PM +0300, Laurent Pinchart wrote:
> Hi Ricardo,
> 
> Thank you for the patch.
> 
> On Tuesday, 2 October 2018 16:30:57 EEST Ricardo Ribalda Delgado wrote:

...

> > +- clock-frequency = Frequency of the xclk clock. (Currently the
> > +	driver only supports <24000000>).
> 
> Please don't mention drivers in DT bindings. I would drop the reference to the 
> 24 MHz limitation.
> 
> I would actually drop the property completely :-) I don't see why you need it, 
> and you don't make use of it in the driver.

Would you rely on assigned-clock-rates or what? There's no guarantee it'll
actually be the desired frequency. That said, few (or no) drivers checks
what they get when they set the frequency.

> 
> > +Optional Properties:
> > +- flash-leds: See ../video-interfaces.txt
> > +- lens-focus: See ../video-interfaces.txt
> > +
> > +The imx274 device node should contain one 'port' child node with

s/should/shall/?

If there's a need to support no port nodes, then say "one or none" or such.
Usually that's useful on the receiver side only though.

> > +Example:
> > +
> > +	camera_rear@1a {
> > +		compatible = "sony,imx214";
> > +		reg = <0x1a>;
> > +		vdddo-supply = <&pm8994_lvs1>;
> > +		vddd-supply = <&camera_vddd_1v12>;
> > +		vdda-supply = <&pm8994_l17>;
> > +		lens-focus = <&ad5820>;
> > +		enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>;
> > +		clocks = <&mmcc CAMSS_MCLK0_CLK>;
> > +		clock-names = "xclk";
> > +		clock-frequency = <24000000>;
> > +		port {
> > +			imx214_ep: endpoint {
> > +				clock-lanes = <0>;

I'd only put clock-lanes if the lane ordering is configurable.

> > +				data-lanes = <1 2 3 4>;
> > +				link-frequencies = /bits/ 64 <480000000>;
> > +				remote-endpoint = <&csiphy0_ep>;
> > +			};
> > +		};
> > +	};

-- 
Kind regards,

Sakari Ailus
sakari.ailus@xxxxxxxxxxxxxxx