Re: [PATCH v2 1/2] net/ncsi: Add NCSI Broadcom OEM command

[Samuel Mendoza-Jonas]

On Tue, 2018-10-09 at 10:48 -0700, Vijay Khemka wrote:
> This patch adds OEM Broadcom commands and response handling. It also
> defines OEM Get MAC Address handler to get and configure the device.
> 
> ncsi_oem_gma_handler_bcm: This handler send NCSI broadcom command for
> getting mac address.
> ncsi_rsp_handler_oem_bcm: This handles response received for all
> broadcom OEM commands.
> ncsi_rsp_handler_oem_bcm_gma: This handles get mac address response and
> set it to device.
> 
> Signed-off-by: Vijay Khemka <vijaykhemka@xxxxxx>
> ---
>  net/ncsi/Kconfig       |  6 ++++
>  net/ncsi/internal.h    |  8 +++++
>  net/ncsi/ncsi-manage.c | 70 +++++++++++++++++++++++++++++++++++++++++-
>  net/ncsi/ncsi-pkt.h    |  8 +++++
>  net/ncsi/ncsi-rsp.c    | 40 +++++++++++++++++++++++-
>  5 files changed, 130 insertions(+), 2 deletions(-)
> 

<snip>

>  static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
>  {
>  	struct ncsi_dev *nd = &ndp->ndev;
> @@ -643,9 +676,10 @@ static void ncsi_configure_channel(struct ncsi_dev_priv *ndp)
>  	struct ncsi_channel *nc = ndp->active_channel;
>  	struct ncsi_channel *hot_nc = NULL;
>  	struct ncsi_cmd_arg nca;
> +	struct ncsi_oem_gma_handler *nch = NULL;
>  	unsigned char index;
>  	unsigned long flags;
> -	int ret;
> +	int ret, i;
>  

I just noticed that if CONFIG_NCSI_OEM_CMD_GET_MAC is not set then this
generates unused variable warnings for i and nch. Otherwise all looking good!

Regards,
Sam