Re: [PATCH v3 2/9] dt-bindings: ti-lmu: Remove LM3697

[Dan Murphy]

Pavel

On 10/11/2018 01:27 PM, Pavel Machek wrote:
> On Thu 2018-10-11 11:51:16, Dan Murphy wrote:
>> Remove support for the LM3697 LED device
>> from the ti-lmu.  The LM3697 will be supported
>> via a stand alone LED driver.
>>
>> Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
> 
> NAK.

Thanks for the NAK.

This NAK was NAK'd by other maintainer in the V2 RFC patchset

https://lore.kernel.org/patchwork/patch/993171/

> 
> 								Pavel
> 								
>> index c885cf89b8ce..920f910be4e9 100644
>> --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt
>> +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt
>> @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below.
>>    LM3632       Backlight and regulator
>>    LM3633       Backlight, LED and fault monitor
>>    LM3695       Backlight
>> -  LM3697       Backlight and fault monitor
>>  
>>  Required properties:
>>    - compatible: Should be one of:
>> @@ -18,11 +17,10 @@ Required properties:
>>                  "ti,lm3632"
>>                  "ti,lm3633"
>>                  "ti,lm3695"
>> -                "ti,lm3697"
>>    - reg: I2C slave address.
>>           0x11 for LM3632
>>           0x29 for LM3631
>> -         0x36 for LM3633, LM3697
>> +         0x36 for LM3633
>>           0x38 for LM3532
>>           0x63 for LM3695
>>  
>> @@ -38,7 +36,6 @@ Optional nodes:
>>      Required properties:
>>        - compatible: Should be one of:
>>                      "ti,lm3633-fault-monitor"
>> -                    "ti,lm3697-fault-monitor"
>>    - leds: LED properties for LM3633. Please refer to [2].
>>    - regulators: Regulator properties for LM3631 and LM3632.
>>                  Please refer to [3].
>> @@ -220,24 +217,3 @@ lm3695@63 {
>>  		};
>>  	};
>>  };
>> -
>> -lm3697@36 {
>> -	compatible = "ti,lm3697";
>> -	reg = <0x36>;
>> -
>> -	enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
>> -
>> -	backlight {
>> -		compatible = "ti,lm3697-backlight";
>> -
>> -		lcd {
>> -			led-sources = <0 1 2>;
>> -			ramp-up-msec = <200>;
>> -			ramp-down-msec = <200>;
>> -		};
>> -	};
>> -
>> -	fault-monitor {
>> -		compatible = "ti,lm3697-fault-monitor";
>> -	};
>> -};
> 


-- 
------------------
Dan Murphy