Re: [PATCH v6 2/2] dt-binding: spi: Document Macronix controller bindings

[Boris Brezillon]

+Rob and the DT ML

Hi Mason,

Remember to Cc the DT mailing list and maintainers when you add/update a
binding.

On Wed, 17 Oct 2018 10:08:12 +0800
masonccyang@xxxxxxxxxxx wrote:

> From: Mason Yang <masonccyang@xxxxxxxxxxx>
> 
> Document the bindings used by the Macronix controller.
> 
> Signed-off-by: Mason Yang <masonccyang@xxxxxxxxxxx>
> ---
>  Documentation/devicetree/bindings/spi/spi-mxic.txt | 34 ++++++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/spi/spi-mxic.txt
> 
> diff --git a/Documentation/devicetree/bindings/spi/spi-mxic.txt b/Documentation/devicetree/bindings/spi/spi-mxic.txt
> new file mode 100644
> index 0000000..529f2da
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/spi/spi-mxic.txt
> @@ -0,0 +1,34 @@
> +Macronix SPI controller Device Tree Bindings
> +--------------------------------------------
> +
> +Required properties:
> +- compatible: should be "mxicy,mx25f0a-spi"
> +- #address-cells: should be 1
> +- #size-cells: should be 0
> +- reg: should contain 2 entries, one for the registers and one for the direct
> +       mapping area
> +- reg-names: should contain "regs" and "dirmap"
> +- interrupts: interrupt line connected to the SPI controller
> +- clock-names: should contain "ps_clk", "send_clk" and "send_dly_clk"

The _clk suffix is unnecessary in my opinion. How about:

- clock-names: should contain "ps", "send" and "send_dly"

Other than that,

Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>

> +- clocks: should contain 3 entries for the "ps_clk", "send_clk" and
> +	  "send_dly_clk" clocks
> +
> +Example:
> +
> +	spi@43c30000 {
> +		compatible = "mxicy,mx25f0a-spi";
> +		reg = <0x43c30000 0x10000>, <0xa0000000 0x20000000>;
> +		reg-names = "regs", "dirmap";
> +		clocks = <&clkwizard 0>, <&clkwizard 1>, <&clkc 18>;
> +		clock-names = "send_clk", "send_dly_clk", "ps_clk";
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		flash@0 {
> +			compatible = "jedec,spi-nor";
> +			reg = <0>;
> +			spi-max-frequency = <25000000>;
> +			spi-tx-bus-width = <4>;
> +			spi-rx-bus-width = <4>;
> +		};
> +	};