[PATCH v2 16/17] thermal: zx2967: enable+check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

Enable+check sensor after checking sensor coefficients.

Cc: Jun Nie <jun.nie@xxxxxxxxxx>
Cc: Baoyou Xie <baoyou.xie@xxxxxxxxxx>
Cc: Shawn Guo <shawnguo@xxxxxxxxxx>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@xxxxxxxxxxx>
---
 drivers/thermal/zx2967_thermal.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/zx2967_thermal.c b/drivers/thermal/zx2967_thermal.c
index 3c08e1d..4e30b1f 100644
--- a/drivers/thermal/zx2967_thermal.c
+++ b/drivers/thermal/zx2967_thermal.c
@@ -168,9 +168,6 @@ static int zx2967_thermal_probe(struct platform_device *pdev)
 		goto disable_clk_all;
 	}
 
-	thermal_zone_set_mode(priv->tzd, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check(priv->tzd);
-
 	if (priv->tzd->tzp->slope == 0) {
 		thermal_zone_of_sensor_unregister(&pdev->dev, priv->tzd);
 		dev_err(&pdev->dev, "coefficients of sensor is invalid\n");
@@ -178,6 +175,9 @@ static int zx2967_thermal_probe(struct platform_device *pdev)
 		goto disable_clk_all;
 	}
 
+	thermal_zone_set_mode(priv->tzd, THERMAL_DEVICE_ENABLED);
+	thermal_zone_device_check(priv->tzd);
+
 	priv->dev = &pdev->dev;
 	platform_set_drvdata(pdev, priv);
 
-- 
1.9.1